Primera Technology LX900 user manual Toc

Page 19

TOC

INDEX

There are two different output modes:

Present labels? - Yes (Default). This setting will cause the printer to feed the last label printed forward so that it and the previously printed labels can be torn off using the tear bar. If no other jobs are sent to the printer within one second after the last label has printed, the last printed label will present for tear off.

Present labels? - No (Use with Rewinder). In this mode the label stock does not move after the last label is printed. This means that part of the last label printed is still in the printer.

This should be used only if you have a label rewinder attached. To retrieve the final label you must press the Load/Feed button on the printer control panel.

Label Stock 15

Image 19

Contents 062211-511271 All rights reserved Printing History Table of Contents Interactive Feature Thank YOU… Getting StartedChoosing a Good Location Unpacking and Inspection Identifying the Parts Recommended PC Specifications Computer SpecificationsLabel Stock Label and Roll SpecificationsTOC Index Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Printing Using NicelabelTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Portrait Landscape Paper SizeColor Matching Ink Saturation Solving Print Alignment Problems Troubleshooting and MaintenanceImage is Vertically Offset Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Create a Support Report Cleaning the PrinterCleaning the Printhead 3C. Preventing clogged nozzles 3B. Deep clean the cartridgeSemi-Permanent Print Head Part Number Printhead / Cartridge Replacement ProcedureInk Feed Unload Press Pause + Load/Feed to Start and Finish Replacing the PrintheadTOC Now align the print head as described in B Source Location Interpreting the PRINTER’S Indicator LightsExplanation Technical SupportMedia Types Section Technical SpecificationsDPI Index11, 33, 35