Fujitsu FD-1008AT, FD-1016AT Switching the Server, Selecting the Server when the Power is on

Page 27

Switching the Server

A server can be selected from the OSD menu (Hot Key Mode). When a currently selected server is turned OFF, that state will be maintained. In this case, switch the desired server in the Hot Key Mode.

Keyboard/mouse operations are enabled only on the server currently connected to the selected port. Operation data is not sent to other servers.

Note, however, that commands from servers are processed at all times even if the server is not selected. For this reason, modes (Key Code mode, LED state, type-setting, Mouse Output Mode, etc.) are reflected when the server is switched.

Selecting the Server when the Power is ON

When the power is turned ON with the power of all servers OFF, the server that was first turned ON is automatically selected.

When servers are turned ON at the same time, Servers are selected and connected in numerical sequence (1, 2, 3 …).

Selecting the Hot Key Mode

There are two Hot Key Modes: A and B. There are four ways of displaying the Hot Key Mode as follows:

Hot Key Mode A

Press and release the Hot-Key switch.

Hold down the <Ctrl>, <Alt>, <Shift> keys at the same time and release.

Press Scroll Lock twice (Press the Scroll Lock key quickly in succession) Hot Key Mode B

Press Ctrl twice (Press the Ctrl key quickly in succession)

* Enabled/disabled can be set according to the DIP switch settings.

When the Hot Key Mode is activated, the OSD (On Screen Display) selection screen is shown on the monitor.

The Scroll Lock LED on the keyboard blinks fast.

Other LEDs (Num Lock LED, Caps Lock LED, Compose, kana) go out. Keyboard/mouse entry is not possible in the Hot Key Mode. The following shows the indications at each of the connections.

*When there is no image (H/V Sync) signal from the currently connected server (suspended state), display the OSD menu by the image (H/V Sync) signals from other ports. At this time, the OSD menu flashes at 5-second cycles.

The normal state is returned to an image (H/V Sync) signal is input to the currently selected port.

*H Sync: Horizontal sync signal

*V Sync: Vertical sync signal

24

Image 27
Contents Servis Fujitsu Component AMERICA, INC Page Contents Preface ConventionsPacking List Page Important Notices Safety PrecautionsSafety Instructions Moving Console Drawer DisposalInstalling the Guide Rails when using a tapped guide rail InstallationInstalling tapped guide rails diagram Installing Console Drawer Names and Functions of Parts Connector for Sun Power cable connectorConnectors for servers 1 through DIP SwitchesOFF Connect the servers Connecting and Removing CablesConnecting Cables Getting started Connect the power cablePage Removing Cables Operating the Console Drawer OperationOpen the monitor completely Opening the LCD diagram Adjusting the Monitor Basic Adjustment Procedure DOS Mode Resolution and Refresh Rate Hot-Key SW operations Keyboard Operation, LED Indicators and the Reset SWPointing Device Operation Switching the Server Selecting the Server when the Power is onSelecting the Hot Key Mode OSD in a non-cascaded connection Hot Key Mode a Hot Key Mode B Page Page Auto Scan Mode Switching in Hot Key Mode BScreen Details Setting/Changing Server NamesConstant Server Name Display Function Edid Setting Mode Storing Console Drawer Clean the keyboard and pointing device with a sterile cloth Cleaning Console DrawerSpecification Technical SpecificationsProduct ID Remark Optional Accessories Sold separatelySymptom Cause Action TroubleshootingSymptom Cause Action Page Reprinting of this manual without permission is prohibited This manual is made of recycled paper