4.Locate the DIMM connectors on the system board. Determine the connectors into which you will install the DIMMs. Install the DIMMs in the sequence shown in the following table.
Number of DIMMs | Connector sequence |
|
|
One DIMM | 1 |
|
|
Two DIMMs (interleaved configuration) | 1, 3 |
|
|
Three DIMMs | Not supported |
|
|
Four DIMMs (interleaved configuration) | 1, 3, 2, 4 |
|
|
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the clips gently.
5.Open the retaining clips and, if necessary, remove any existing DIMM.
6.Touch the
7.Turn the DIMM so that the DIMM keys align correctly with the slot.
8.Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of the DIMM connector. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated in the connector. If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly installed. Open the retaining clips, remove the DIMM, and then reinsert it.
If you have other options to install or remove, do so now; otherwise, go to “Completing the installation” on page 28.
Chapter 2. Installing options 15