DR300 Operator Manual | Chapter 5 - Power Supply |
|
|
Simple Troubleshooting
Confirm the following items when operation of this equipment failed even though power supply is switched on.
Nothing is shown on the display
| Check Point |
| Remedy |
1. | Is the power cable firmly plugged | Plug power cable again into the outlet | |
| into the power outlet? | firmly. |
|
2. | Is the power cable firmly plugged | Plug power cable again into the power | |
| into the equipment? | connector on the main body firmly. | |
3. | Is the power cable damaged? | Replace power cable. | |
4. | Is the fuse on the main body blown? | Check the fuse at the right side of main | |
|
| body. | If it is blown, replace with |
|
| equivalent fuse. | |
|
| If it blows again after it is replaced, contact | |
|
| SATO service engineer. | |
|
| *Please ensure printer is disconnected from | |
|
| the mains before exchanging fuse. | |
5. | Is there current supplied to the | Check power source for power supply | |
| equipment? | outlet. | If there is no problem with the |
|
| power source, check the electricity supply | |
|
| of the building. | |
|
| Check for any power shut down. | |
6. | Is the power source fuse or the | Contact the building maintenance office. | |
| circuit breaker for the building |
|
|
| blown or tripped? |
|
|
•Do not operate power switch or plug in / out power cable with wet hands to avoid electrocution.
•Disconnect printer from mains before cleaning.
27