Xantrex Technology ACCB-L-L1 manual Pre-Installation, Location, Service Planning

Installation

Pre-Installation

WARNING: Shock Hazard

Ensure that no DC voltage is being supplied to the inverter and that no AC voltage is present on the AC wiring. Failure to do so could cause serious injury or death. A warning label is provided to inform all personnel that multiple sources of power are available inside. This label should be installed on the outside cover to be clearly visible. Ensure all sources are OFF or disconnected before servicing.

WARNING

ELECTRICAL SHOCK

HAZARD

PN 3550

THIS ELECTRICAL SYSTEM IS EQUIPPED WITH A

DC TO AC POWER INVERTE R. DISCONNECT THE

DC AND AC SOURCES BEFORE SERVICING.

Figure 2-1Shock Hazard Warning Label

Location

Be sure to allow sufficient space for the Long AC Conduit Box to be mounted directly adjacent to the inverter’s AC side. Be sure to leave room for expansion if necessary. Also consider the additional weight and ventilation space requirements of the Long AC Conduit Box.

Service Planning

If for any reason the inverter may need service or needs to be removed from the position where it’s mounted, the following recommendations should be considered to make this task easier.

To make servicing the inverter easier to accomplish:

•Use flexible conduit.

•When mounting the components such as the ACCB-L or DCCB-L next to the inverter, bias the mounting screws away from the inverter. This will allow "sliding" room within the mounting holes, so that the ends can slide apart without being removed from their mounted position.

Figure 2-10, “Installing the ACCB-L to the SW Plus Inverter on Plywood” on page 2–13 for details.

2–4 973-0031-01-01 Rev A