Xantrex Technology ACCB-L-L1 manual Mounting on the Xantrex Back Plate XBP

Mounting

Mounting

The Long AC Conduit Box is designed to mount directly to the AC side of a Sine Wave Plus inverter. However, the SW Plus inverter can weigh up to 136 pounds (62 kg). The ACCB-L weighs up to 27 lbs (12.2 kg). Ensure the supporting surface is strong enough to hold twice the total weight being installed. Remember to include the weight of any other accessory, such as the DC Conduit Box, when considering the strength of the supporting surface.

Xantrex provides a steel back plate (XBP) that provides the additional support. A sheet of 3/4" plywood could also provide adequate support.

Mounting on the Xantrex Back Plate (XBP)

A two-piece, steel back plate is available for providing extra support to the mounting surface. The back plate comes with mounting hooks that can be attached to the panel to hang the components on as they’re installed.

Pass-thru holes for conduits running through the back of the back plate

Mounting Hook

Location for the

ACCB-L

Hand Holds

Hand Holds

Pass-thru holes for conduits running through the back of the back plate

Side View

XBP	XBP
Left Side	Right Side

35"

(89 cm)

46" (117 cm)

Figure 2-8The Xantrex Back Plate

To mount the Long AC Conduit Box on the Back Plate (XBP):

1.Install the mounting hook (if used) onto the backplate in the position indicated in Figure 2-8 for the Long AC Conduit Box. See the XBP Installation Instructions for details.

2.Mount the backplate to the supporting surface according to the instructions provided with the XBP Installation Instructions.

973-0031-01-01 Rev A 2–11