Xantrex Technology ACCB-L manual Mounting on Plywood, To mount the Long AC Conduit Box on plywood

Mounting

Mounting on Plywood

Mounting holes and keyhole slots for ACCB-L (x6)

Plywood

ACCB-L Base with top cover removed

Bias the screws (top and bottom) away from the inverter for easier servicing if necessary

Important: Ensure that the factory-installed cables in the Long AC Conduit Box are not pinched, crushed, removed, or damaged during the installation to the inverter.

To mount the Long AC Conduit Box on plywood:

1.With the help of another person, lift the inverter and mount it into place. Secure it to the plywood with #10 wood screws (14 total - length to penetrate 1½ inches or more into the studs.) See the Sine Wave Plus Inverter/Charger Owner’s Manual for more specific mounting instructions for the inverter.

2.Line up the Long AC Conduit Box at the AC end of the inverter, so that the mounting rails are aligned together and the Long AC Conduit Box base is as close to the inverter as possible. The gap between the Long AC Conduit Box and the inverter should be no more than 1/16 inch.

3.Secure the Long AC Conduit Box in place with six #10 wood screws of an appropriate length (or lag bolts) in the six mounting and keyhole slots on the mounting rails of the ACCB. Bias the screws away from the inverter.

4.Leave the top cover off the Long AC Conduit Box to proceed with wire connections.

Align Mounting Rails

Figure 2-10Installing the ACCB-L to the SW Plus Inverter on Plywood

973-0031-01-01 Rev A 2–13