Transition Networks MIL-SW8T1GPA manual Desktop Installation, Power On, Attaching Rubber Pads

Page 12

 

 

Blinks

 

Orange

Collision of Packets occurs in the

 

 

 

port

 

 

 

 

 

 

 

 

 

 

 

 

 

Off

 

--

Half-duplex mode or no device

 

 

 

attached

 

 

 

 

 

 

 

 

 

 

 

 

 

On

 

Green

The port is successfully connecting

 

 

 

with the device

 

 

 

 

 

 

 

 

 

 

 

 

LNK /ACT

Blinks

 

Green

The port is receiving or transmitting

 

 

 

 

(MINI GBIC)

 

data

 

 

 

 

 

 

 

 

 

 

 

 

Off

 

--

No data transmitted or no device

 

 

 

connected

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The Description of LED Indicators

Desktop Installation

Set the switch on a sufficiently large flat space with a power outlet nearby. The surface where the switch locates should be clean, smooth, level and sturdy. Make sure there is enough clearance around the switch to allow attachment of cables, power cord and allow air circulation.

Attaching Rubber Pads

A.Make sure mounting surface on the bottom of the switch is grease and dust free.

B.Remove adhesive backing from the Rubber Pads.

C.Apply the Rubber Pad to each corner on the bottom of the switch. These footpads can prevent the switch from shock/vibration.

Power On

Connect the power adaptor to the power jag on the rear panel of the switch. The

10

Image 12
Contents User Guide Five-Year Limited Warranty Content Technical Specification Features IntroductionSoftware Feature Firmware updateSystem default ManagementPackage Contents Page Physical dimension Reset buttonFront Panel Rear Panel LED Indicators PowerStatus Color Description 1000MDesktop Installation Power OnAttaching Rubber Pads Page Network Application Small WorkgroupSegment Bridge Page System Login About Web-based ManagementSystem Configuration Active IP Address Current IP AddressActive Gateway Current Gateway System Configuration interface Port Configuration Statistics Overview Vlan Setting Statistics DetailVlan Port Setting Port Trunk Lacp Setting Lacp Status Rstp System Configuration Spanning TreeRstp Configuration interface Rstp Port Configuration Spanning Tree Status802.1X Configuration Parameters Configuration QoS Setting QoS Configuration interface QoS Dscp Mapping interface Factory Default System RestartFirmware Upload Configuration File Transfer Faulty or loose cables Incorrect connectionsNon-standard cables Diagnosing LED Indicators Improper Network TopologiesLED Indicators StandardProtocol TechnologyConnector DimensionsPower Supply Power ConsumptionSafety Operating Humidity