Transition Networks MIL-SW8T1GPA manual Vlan Port Setting

Page 23

And then, click

Apply

to bring up the configuration interface as below:

VLAN Setting interface

VLAN Port Setting

Click

VLAN Port Setting

to bring up the configuration interface for adjusting the

VID Setting

PVID: Enter the Port VLAN ID

Awareness: Enable the awareness that ports will strip the VLAN tag from received frames and insert the tag in transmitted frames (PVID). Disable the awareness that ports will not strip the tag from received frames or insert the tag

21

Image 23

Contents User Guide Five-Year Limited Warranty Content Technical Specification Introduction FeaturesManagement Software FeatureFirmware update System defaultPackage Contents Page Front Panel Physical dimensionReset button Rear Panel 1000M LED IndicatorsPower Status Color DescriptionAttaching Rubber Pads Desktop InstallationPower On Page Small Workgroup Network ApplicationSegment Bridge Page About Web-based Management System LoginActive Gateway Current Gateway System ConfigurationActive IP Address Current IP Address System Configuration interface Port Configuration Statistics Overview Statistics Detail Vlan SettingVlan Port Setting Port Trunk Lacp Setting Lacp Status Spanning Tree Rstp System ConfigurationRstp Configuration interface Spanning Tree Status Rstp Port Configuration802.1X Configuration Parameters Configuration QoS Setting QoS Configuration interface QoS Dscp Mapping interface Firmware Upload Factory DefaultSystem Restart Configuration File Transfer Non-standard cables Faulty or loose cablesIncorrect connections Improper Network Topologies Diagnosing LED IndicatorsTechnology LED IndicatorsStandard ProtocolPower Consumption ConnectorDimensions Power SupplyOperating Humidity Safety