Transition Networks MIL-SW8T1GPA manual Parameters Configuration

Page 31

Or, click

Refresh to reset the configuration before applying

802.1X Configuration interface

Parameters Configuration

Reauthentication Enable: To enable the re-authentication mode

Reauthentication period (1~3600 seconds): Set the period of time after which clients connected must be re-authenticated

EPA Timeout (1~255 seconds): Set the period of time the switch waits for a supplicant response to an EAP request

And then, click Apply to apply the configuration

Or, click

Refresh to reset the configuration before applying

29

Image 31

Contents User Guide Five-Year Limited Warranty Content Technical Specification Introduction FeaturesManagement Software FeatureFirmware update System defaultPackage Contents Page Reset button Physical dimensionFront Panel Rear Panel 1000M LED IndicatorsPower Status Color DescriptionPower On Desktop InstallationAttaching Rubber Pads Page Small Workgroup Network ApplicationSegment Bridge Page About Web-based Management System LoginActive IP Address Current IP Address System ConfigurationActive Gateway Current Gateway System Configuration interface Port Configuration Statistics Overview Statistics Detail Vlan SettingVlan Port Setting Port Trunk Lacp Setting Lacp Status Spanning Tree Rstp System ConfigurationRstp Configuration interface Spanning Tree Status Rstp Port Configuration802.1X Configuration Parameters Configuration QoS Setting QoS Configuration interface QoS Dscp Mapping interface System Restart Factory DefaultFirmware Upload Configuration File Transfer Incorrect connections Faulty or loose cablesNon-standard cables Improper Network Topologies Diagnosing LED IndicatorsTechnology LED IndicatorsStandard ProtocolPower Consumption ConnectorDimensions Power SupplyOperating Humidity Safety