Transition Networks MIL-SW8T1GPA manual Spanning Tree Status, Rstp Port Configuration

Page 29

RSTP Port Configuration

￿Protocol Enable: To enable or disable the port protocol

￿Edge: The port directly connected to end stations cannot create bridging loop in the network. To configure the port as an edge port, mark the port

￿Path Cost: The cost of the path to the other bridge from this transmitting bridge at the specified port. Enter a number 1 through 200000000

￿And then, click

Apply

to apply the configuration

￿Or, click

Refresh to reset the configuration before applying

Spanning Tree Status

Click

Refresh to get the newest configuration information. Also, the RSTP VLAN

Bridge information will display as below:

27

Image 29
Contents User Guide Five-Year Limited Warranty Content Technical Specification Introduction FeaturesFirmware update Software FeatureSystem default ManagementPackage Contents Page Front Panel Physical dimensionReset button Rear Panel Power LED IndicatorsStatus Color Description 1000MAttaching Rubber Pads Desktop InstallationPower On Page Small Workgroup Network ApplicationSegment Bridge Page About Web-based Management System LoginActive Gateway Current Gateway System ConfigurationActive IP Address Current IP Address System Configuration interface Port Configuration Statistics Overview Statistics Detail Vlan SettingVlan Port Setting Port Trunk Lacp Setting Lacp Status Spanning Tree Rstp System ConfigurationRstp Configuration interface Spanning Tree Status Rstp Port Configuration802.1X Configuration Parameters Configuration QoS Setting QoS Configuration interface QoS Dscp Mapping interface Firmware Upload Factory DefaultSystem Restart Configuration File Transfer Non-standard cables Faulty or loose cablesIncorrect connections Improper Network Topologies Diagnosing LED IndicatorsStandard LED IndicatorsProtocol TechnologyDimensions ConnectorPower Supply Power ConsumptionOperating Humidity Safety