IBM RS/6000 44P manual Appendix E. Modem Configurations

# factory default settings.
ICDelay 1
DefaultTO 10
CallDelay 120
#	AT	Attention Code	,	Inserts delay in dialing commands
# &F0		Reset. Restore profile 0 Q0		Turn on responses
#	E0	Turn echo off	Q1	Turn off responses
#	V0	Use numeric responses	S0=0	Automatic answer inhibit
# +++		Escape to command mode	S0=2	Answer on second ring
#	H0	Hang-up	X0=0	Limit modem response codes
#			T =	Tone mode. When used as T\r, it is a
#				no op to maintain program synchronization
#				when modem may/will echo the commands.
#
# &C1		Detect CD	&D2	Respond to DTR (often the default)
# &R1		Ignore RTS (CTS)
#
#	%N	Call-Out phone number	%P	Paging phone number

#%S Modem speed (available to users)

#Following are common responses from a wide range of modems:

#16, 15, 12, 10, 5 and 1 are connection responses. Add others as required.

#7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; 0=OK

#

# PROGRAMMING NOTE: No blanks between double quote marks (").

condout:	send "AT&F0Q0T\r"	# Reset modem.		Select profile 0
	ignore "0\r" or "OK\r\n" timeout 2	# Ignore modem		response.
	send "ATE0T\r"	# Initialize modem: Echo OFF,
	expect "0\r" or "OK\r\n" timeout 2	#	Enable responses (Numeric),
	send "ATQ0V0X0T\r"	#	Limit response codes.
	expect "0\r" timeout 2	# Confirm commands successful.
	send "ATS0=0\r"	# Set AutoAnswer OFF
	expect "0\r" timeout 2	# Confirm command successful.
	send "AT&C1&D2&R1\r"	# Detect carrier and DTR,
		#	Ignore RTS.
	expect "0\r" timeout 2	# Confirm command successful.
	done
connect:	send "ATDT%N\r"	# Tone dialing		command.
		# %N from Call		Home setup.

# Expect a connection response.

expect "16\r" or "15\r" or "14\r" or "12\r" or "10\r" or "5\r" or "1\r" busy "7\r" timeout 60

done

retry: send "A/" # Repeat the previous command.

# Expect a connection response.

expect "16\r" or "15\r" or "14\r" or "12\r" or "10\r" or "5\r" or "1\r" busy "7\r" timeout 60

done

Appendix E. Modem Configurations 185