IBM RS/6000 44P manual Sample File modemz0.cfg

	expect "0\r" or "OK\r\n" timeout 2		#	Enable responses (Numeric),
	send	"ATQ0V0T\r"	#	Limit response codes.
	expect "0\r" timeout 2		# Confirm commands successful.
	send	"ATS0=2\r"	# Set AutoAnswer ON
	expect "0\r" timeout 2		# Confirm command successful.
	done
waitcall: ignore		"2\r" timeout 1	# Ignore first ring.
	expect	"2\r" timeout 10	# Pick up second ring
			#	or timeout.
			# Expect a connection response.
expect "16\r" or "15\r" or "14\r" or "12\r" or "10\r" or "5\r" or "1\r"
timeout 60
	done
page:	send	"ATDT%N,,,,%R;\r"	# %N = pager call center number
			# Add enough commas to wait for
			#	time to enter paging number.
			# %R = paging number
	expect "0\r" timeout 60		# Confirm successful command.
	delay 2		# Wait before hanging up.
	send	"ATH0T\r"		# Hang up.
	expect "0\r" timeout 2		# Confirm successful command.
	done
ripo:	send	"ATZQ0T\r"	# Reset to factory defaults.
	ignore "0\r" or "OK\r\n" timeout 2		# Ignore modem response.
	send	"ATE0T\r"	# Initialize modem: Echo OFF,
	expect "0\r" or "OK\r\n" timeout 2		#	Enable responses (Numeric),
	send	"ATQ0V0T\r"	#	Limit response codes.
	expect "0\r" timeout 2		# Confirm commands successful.
	send	"ATS0=0\r"	# Set AutoAnswer OFF
	expect "0\r" timeout 2		# Confirm command successful.
	done		# RI Power On enabled.
error:			# Handle unexpected modem
			#	responses.

expect "8\r" or "7\r" or "6\r" or "4\r" or "3\r" delay 2

done

Sample File modem_z0.cfg

#

#COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP Z0

#FUNCTIONS: Modem configuration file for some early Hayes* compatible modems.

#This example uses the ATZ0 reset command to choose the factory defaults.

#This setup is recommended for modems that will respond to the ATZ0 command

#and which do not respond to the extended (&) commands. Refer to your modem

#manual.

#

#* Trademark of Hayes Microcomputer Products, Inc.

Appendix E. Modem Configurations 179