IBM RS/6000 44P manual Symptom Action

Symptom	Action
The diskette LED is blinking rapidly, or E1EA or	The flash EPROM data is corrupted. Run the
E1EB is displayed on the operator panel.	recovery procedure for the flash EPROM.
The system stops with a prompt to enter a	Enter the password. You are not allowed to
password.	continue until a correct password has been
	entered. When you have entered a valid
	password, wait for one of the other conditions
	to occur.
The system stops with an eight-digit error	Record the error code(s) and report the
code(s) displayed on the console.	problem to the service organization.
The system login prompt is displayed.	You may not have pressed the correct key, or
	you may not have pressed the key soon
	enough when you were to indicate a Service
	Mode boot of diagnostic programs. If this was
	the case, start over at the beginning of this
	step.
	If you are sure you pressed the correct key in a
	timely manner go to Step 7.
The system does not respond when the	Go to Step 7.
password is entered.
The system stopped and an indicator is	If the indicator (text or icon) represents:
displayed on the system console and an	v A keyboard, record error code M0KBD000
eight-digit error code is not displayed.
	and report the problem to the service
	organization.
	v Memory, record error code M0MEM002 and
	report the problem to the service
	organization.
	v SCSI, record error code M0CON000 and
	report the problem to the service
	organization.
	v Network, record error code M0NET000 and
	report the problem to the service
	organization.
	v Speaker/Audio, record error code M0BT0000
	and report the problem to the service
	organization.

15844P Series Model 170 User's Guide