If the system was powered on when the ac loss occurred, the system reboots when power is restored. If the system was powered off when the ac loss occurred, the system remains off when power is restored.
Configure Surveillance Policy
This service aid monitors the system for hang conditions; that is, hardware or software failures that cause operating system inactivity. When enabled, and surveillance detects operating system inactivity, a call is placed to report the failure.
Use this service aid to display and change the following settings for the Surveillance Policy.
Note: Some of the following settings may not be displayed by this service aid.
vSurveillance
vSurveillance Time Interval, in minutes
Maximum time between heartbeats from the operating system.
vSurveillance Delay, in minutes
Time to delay between when the operating system is in control and when to begin operating system surveillance.
vChanges are to take effect immediately
Set this to yes if the changes made to the settings in this menu are to take place immediately. Otherwise, the changes take effect beginning with the next system boot.
You can access this service aid directly from the AIX command line by entering:
/usr/lpp/diagnostics/bin/uspchrp
Create Customized Configuration Diskette
This selection invokes the Diagnostic Package Utility Service Aid, which allows the user to create a
The
vDefault refresh rate for a LFT (Limited Function Terminal)
The refresh rate used by the
vDifferent async terminal console
Use this service aid to create a console configuration file that allows a terminal attached to any RS232 or RS422 adapter to be selected as a console device. The default device is RS232 TTY attached to the first standard serial port (S1).
Delete Resource from Resource List
Use this task to delete resources from the resource list.
