Transition Networks MIL-SW8T1GPA manual System Restart, Factory Default, Firmware Upload

Page 35

System Restart

Reboot the switch in software reset. All the configurations will be reminded

Click

Yes

to restart the system

System Restart interface

Factory Default

Reset switch to default configuration

Click

Yes

to reset the all configuration to the default value

Factory Default interface

Firmware Upload

The system provides the Web GUI firmware update function which would allow the user to update the switch firmware.

Click

Browse

to locate the firmware

33

Image 35

Contents User Guide Five-Year Limited Warranty Content Technical Specification Introduction FeaturesManagement Software FeatureFirmware update System defaultPackage Contents Page Front Panel Physical dimensionReset button Rear Panel 1000M LED IndicatorsPower Status Color DescriptionAttaching Rubber Pads Desktop InstallationPower On Page Small Workgroup Network ApplicationSegment Bridge Page About Web-based Management System LoginActive Gateway Current Gateway System ConfigurationActive IP Address Current IP Address System Configuration interface Port Configuration Statistics Overview Statistics Detail Vlan SettingVlan Port Setting Port Trunk Lacp Setting Lacp Status Spanning Tree Rstp System ConfigurationRstp Configuration interface Spanning Tree Status Rstp Port Configuration802.1X Configuration Parameters Configuration QoS Setting QoS Configuration interface QoS Dscp Mapping interface Firmware Upload Factory DefaultSystem Restart Configuration File Transfer Non-standard cables Faulty or loose cablesIncorrect connections Improper Network Topologies Diagnosing LED IndicatorsTechnology LED IndicatorsStandard ProtocolPower Consumption ConnectorDimensions Power SupplyOperating Humidity Safety