Muratec Fax Machine installation manual Soft Keys, Setting the Soft Key, Stamp, Combine Margin

Soft Keys

Soft Keys are shortcut keys. You can program the soft keys on the control panel to turn on or off any function with just the touch of a button. Your machine has four Soft Keys. If the light above any one of these keys glows, that means the setting programmed into that key is active.

These keys are programmed at the factory to turn the following functions on or off:

•Confirmation stamp* (see page 3.71)

•Confirmation report* (see pages 3.40–3.41)

•Monitor/Call* (see page 3.5)

•Memory transmission* (see pages 3.3 and 3.70)

But instead of using the Soft Keys to control the functions above, you can program them to turn other functions on or off. These functions are:

• TTI Tx*— Normally, when you send the fax message, your TTI will be printed at

the top of document you send. If you programmed TTI Tx into a Soft Key, you can

disable to send your TTI by simply pressing that Soft Key.

• Cover page* (see page 3.38)

• Flash* — Lets you quickly disconnect a call and go right to the next one without

having to hang up the handset.

• Security reception (see pages 3.61–3.62)

• Auto reception (see page 3.7)

• Fax Forwarding (see pages 3.36–3.37)

• Combine (see page 2.10)

• Repeat (see page 2.11)

• Series copy (see page 2.13)

Common settings

•Enhanced copy (DocEnhance) — Makes only the light areas, such as the text written with pencil, darken selectively.

•Duplex (see page 2.19)

•Booklet (see page 2.23)

* When you change the setting by using the Soft Key, it will be available only for
the next transmission. Once that transmission is complete, your machine returns				Started
Setting the Soft Key
to its default setting.
1	Press MENU, [Mach Set].	D.Soft Key		Getting
2	Select “D.Soft Key” using the cursor key, and
		Press Soft Key
	then press [Enter].
		1.Stamp	FaxFunc.
	The LCD shows the function name currently
	stored in the Soft key 1.
	Note: If you want to see the all four functions	Exit Show All	Enter
	currently stored in the soft keys, press
	[ShowAll]. However, when you register the other function in the Soft			Settings
	Key, you should press [ShowAll] again to select the Soft Key.
3	Press desired Soft Key (1–4) on the control panel you want to change. Then			Common
	press [Enter].

Note: On the LCD, the shaded functions are currently assigned to the Soft keys.

• Erase Center (see page 2.13)

• Erase Border (see page 2.14)

• TopUp Copy (see page 2.14)

• Binding Margin (see page 2.15)

• Directional Magnification (see page 2.15)

• Nega/Posi (see page 2.16)

• Last Job (see page 2.17)

• Mixed length copy (see page 2.18)

1.Stamp		FaxFunc.
Use cursor to select�
item.
Stamp		Cover Page
Report		Flash
Monitor/Call		Security Rx
Memory Tx		Auto Rx
TTI Tx		Fax Forward
CopyFunc	Cancel Enter

1.StampFaxFunc.

Use cursor to select� item.

Combine Margin

Repeat D.Mag.

Series Copy Nega/Posi

EraseBorder Last Job

EraseCenter TopUp Copy

FaxFunc. Cancel Enter

4.1