Muratec Fax Machine Programming regular polling, Select Polling and press Enter

Delayed Tx

Enter Trnsmit Time� 30/17:05

Next, tell your fax to carry out this delayed command one of these ways:

Advanced fax

Programming regular polling

Note: You cannot program continuous polling into a programmable one-touch key. For more information on continuous polling, see page 3.35.

To program a regular polling operation into a programmable one-touch key:

8

Option 1: Perform the command once at a certain time on a certain day of the month. (For example, “Do this

1 Press MENU, C, [Enter].

The LCD shows the programmable one-touch number list.

2 Select the programmable one-touch number that you want to program or change.

C.Prog.One-Touch

Select p-one-touch.(79-84)

79:

80:

81:

82: 83:

Detail Erase Enter

at 5:05 PM on the 30th.”)

To select this option, use the

numeric keypad to enter the dateClear Enter and time when the fax should perform the command.

Option 2: Perform the command at a cer-	Delayed Tx
		Enter Trnsmit Time�
tain time each day you press the	0	0/17:05
key. (For example, “Do this at 5:05

Note: If you’re changing a previously stored command:

If your previous command for this key was a polling transmission and you want to keep this key programmed for a polling transmission, use these instructions to make changes.

If you want to assign this key to a completely different operation, overwrite a previously stored command to the new one.

PM today.”)
To select this option, use the
numeric keypad to enter 0, 0 and	Clear	Enter
then the time the fax should per-

form the command.

9 Press [Enter], [Exit].

3 Press [Enter].

4 Use the numeric keypad to enter the fax num- ber exactly as your machine should dial it, including whatever codes your phone system requires. The number can be up to 40 charac- ters in length.

79:

Enter fax number.�

_

10 The machine will return to step 2.

Note: When regular polling is programmed, the symbol will appear in the programmable one-touch number list on the LCD.

Note: When the delayed transmission is programmed, the symbol will appear in the programmable one-touch number list on the LCD.

5	Press [Enter].	-	Clear	Enter
6	Select “Polling” and press [Enter].
7	If you want the polling to begin immediately every time you press the key,
	press [Exit] and skip to step 10.

If you want to delay the polling, select “Delayed Tx” and press [Enter].

If you want to enter or change another key’s programming, repeat steps 2-10. If you do not want to enter or change any other key’s programming, press RESET. Your machine returns to standby mode.

3.56