Muratec Fax Machine Settings for transmission, Scan settings, Setting ECM, Resol. Normal

Settings for transmission

Scan settings

Default setting: Primary resolution: Normal, Primary contrast: Normal

Four different settings tell your machine how to scan documents. The initial factory settings are probably right for most applications, so try using them before changing any of these settings:

•Primary resolution mode — Sets the resolution for your documents. Choose either normal, fine, superfine (“S-Fine” on the LCD) or grayscale mode (“Gray”).

•Primary contrast mode — Sets how light or dark you want faxed documents to be when they arrive at their destination.

Note: The primary settings you choose effect your fax activity only.

To set these modes:

01.Scan Settings

Fax settings

Setting ECM

Default setting: ON.

“Line noise,” or static on the line during a call, can easily disrupt the flow of data from one fax machine to another.

That’s why your fax machine gives you the option of using the Error Correction
Mode (ECM). When two fax machines communicate while running in ECM, the send-	Started
ing machine automatically checks the data as it sends. If the receiving fax machine
can’t verify the transmission, the first machine will re-send it as necessary.
Note: ECM gives you a better chance of transmitting a fax document over a bad
	Getting
phone line, but it could also slow down the transmission time. And the worse
the line is, the slower the transmission. That’s why the machine lets you
turn ECM on or off as needed.
Note: Not all fax machines have ECM. If you’ve activated ECM and then transmit to

1 Press MENU, J, 0, 1, [Enter].

2 To set the primary resolution mode, select “Resol.” then press [Enter].

3 Select desired resolution mode, then press [Enter].

4 To set the primary contrast mode, select “Contrast” then press [Enter].

Use cursor to select� item.

Resol. :Normal

Contrast:Normal

ExitEnter

	a fax machine not currently using ECM, there will be no change in the fax
	transmission from a usual, non-ECMtransmission.
			FeaturesFax
1		07.ECM Mode
	Press MENU, J, 0, 7, [Enter].	Use cursor to select�
		ON or OFF.
	The LCD shows the current ECM setting:
2		ON
	Select “On” or “Off” using the cursor key.	OFF

5	Select desired contrast mode using a cursor key, then press [Enter].
6	Press [Exit] to exit this setting mode.
7	Press RESET to return to the standby mode.

By following the steps above, you’ve set your defaults for scanning. Before sending documents, you can “override” these default scan settings for that transmission.

To override the default resolution and contrast settings before sending a document:

•Press RESOLUTION to change the resolution.

•Press CONTRAST to change the contrast.

Once your document is transmitted, your machine returns to its default settings.

3 Press [Enter] to save the setting.

Enter

4 Press RESET to return to the standby mode.

3.69