Muratec Fax Machine If you cannot make clear copies, Symptom Possible cause/ What to do

Just in case

If you cannot make clear copies

Symptom	Possible cause/What to do
The image is too light.	The image contrast is too light.
	Adjust the image contrast by pressing CONTRAST key.
	. . . or . . .
	The toner is low.
	Replace the toner bottle.
	. . . or . . .
	The paper is damp.
	Change the paper.
The image is too dark.	The image contrast is too dark.
	Adjust the image contrast by pressing CONTRAST key.
	. . . or . . .
	The FBS glass surface is dirty.
	Wipe the FBS glass clean with a soft dry cloth.
The copy is blurry.	The paper is damp.
	Change the paper.
The copy has lines.	The FBS glass surface is dirty.
or	Wipe the FBS glass clean with a soft dry cloth.
The copy has dark	. . . or . . .
specks or spots.	The FBS pad is dirty.
	Wipe the FBS pad clean with a soft cloth dampened with
	alcohol.
	. . . or . . .
	The original your document is very thin or highly trans-
	parent.
	Place a blank sheet of paper over the original.
	. . . or . . .
	The original your document is 2-sided.
	The information on the back side of a 2-sided, thin origi-
	nal may be slightly reproduced on the copy. Adjust the
	image contrast level lighter by pressing CONTRAST key.

Symptom	Possible cause/What to do
The edge of the copy is	The FBS pad is dirty.
dirty.	Wipe the FBS pad clean with a soft cloth dampened with
	alcohol.
	. . . or . . .
	You have selected a paper size larger than your original
	document. (When zoom ratio is set as full size 100%)
	Select the same copy paper size as the original.
	. . . or . . .
	The original document is not placed in the correct posi-
	tion. (When zoom ratio is set as full size 100%)
	Select the same copy paper size as the original. Or, reload
	the paper in the same direction as the original.
	. . . or . . .
	The reduction ratio selected is not in accord with the copy
	paper size. (When doing the manual reduction copying.)
	Select the enlarge ratio according to the copy paper size.
The image on the copy	The original document is not placed in the correct
is not aligned properly.	position.
	Place the original correctly on the FBS glass against the
	original width scale. Or, load it into the ADF correctly along
	the document guide.
	. . . or . . .
	The original documents may not be suitable for use in the
	ADF.
	Raise the platen cover and place the originals on the FBS
	glass one at a time, instead of using the ADF.
	. . . or . . .
	Something is sticking to the original document.
	Wipe the FBS glass clean with a soft dry cloth.

5.16