Muratec Fax Machine Canceling Commands, Redialing manually, All redials failed

Press JOB REVIEW & COMM CANCEL.

Basic fax

Redialing

If your fax call fails, your machine automatically redials it. In the Auto Redial mode, your fax automatically redials the number every minute until one of the following hap- pens:

•It reaches the remote fax machine.

•It has attempted the two redials and has still not connected.

While in the Auto Redial mode, the machine can continue to receive faxes and can make as many as 100 fax transmissions.

Note: If you used either the speaker or a handset to dial, you must redial manu- ally (see below).

Note: The default setting of redial attempts is as flowing: Number of redials : 2 times

Redial interval : 1 minute.

You can change this setting as you want. See “Changing redial settings,” page 3.75.

If the last redial attempt fails:

1 The LCD will ask you if it should attempt the redials again:

To redial a fax call manually with the monitor speaker or an optional handset:

1 Make sure the document is in the ADF and that the resolution and contrast are set.

2 Press MONITOR/CALL or lift the optional handset to get a dial tone. 3 Press [Redial].

4 When you hear fax tones from the remote unit, press START.

Note: If a person answers the phone, use the optional handset to tell that person you’re sending a fax. When you hear fax tones, press START.

To redial a voice call manually using the optional handset:

1 Lift the optional handset to get a dial tone.

2 Press [Redial]. When the other person answers, use the optional handset to speak to that person.

Canceling Commands

2 If you want the machine to attempt it again,

All� redials failed.

The Job Review function gives you the power to check on each job (or command) in your machine’s memory. It also lets you cancel a command if you decide not to send the document.

press [Yes].

Otherwise, press [No]. Your machine will print and display error messages.

987-6543

Try again?

Num. of redials :02

Yes No

To cancel a command:

1

2 If your machine is attempting to perform a command now, it will appear on the display. Skip to step 5.

Reserved Transmission

Use cursor to select� command.

C001 15/21:30 L.A.Office

C002 15/21:40 Broadcast

Redialing manually

You can always redial calls manually. And you must redial manually if you use either the monitor speaker or an optional handset to dial the failed call.

Otherwise, proceed to step 3.

3 Select “Reserved Transmission” and then press [Enter]. The list of Reserved Transmission will appear.

B001 15/22:00 Batch Tx

C003 17/08:00 987-6543

C004 17/08:10 N.Y.Office

PrintDoc Location Erase

To redial a fax call manually without using the monitor speaker or an optional handset:

1 Make sure the document is in the ADF and that the resolution and contrast are set.

2 Press [Redial], START.

4 Select the command you want to cancel using the cursor key.

5 Press [Erase].

To return your machine to standby mode, press RESET.

For more information on the Job Review function, see page 3.29.

3.6