Muratec Fax Machine Clearing paper jams, If an original document jams, Case, Just

Clearing paper jams

If an original document jams

If an original document jam occurred during scanning, an alarm sounds and the part the paper jammed will blink on the LCD. Please remove the jammed paper care- fully as below.

Important: If you wait more than 60 seconds without pressing any key, the machine will delete from memory all pages stored during this opera- tion and the machine will return to the standby mode.

Note: If this document is a non-sorting ADF job (either copying or faxing), the machine will abort the operation anyway; instead, you’ll have to perform the job again from scratch.

Note: In Quick memory transmission, the check message will be printed, which has the number of jammed page. Reset the jammed documents and transmit it.

Just in case

3 Open the inner cover as shown at right, then remove the document by turning the green dial right. Then skip to step 5. If you cannot remove the original docu- ment, proceed to step 4.

4	Lift the document tray as shown at	Getting Started
	right, then remove the document.
5	Gently close the inner cover and the ADF
	cover, making sure both sides are

If the ADF cover is blinking on the LCD:

1 Open the ADF cover by holding the ADF cover release.

2 Remove the original document from the machine by turning the green dial right. Then skip to step 5.

If you cannot remove the original docu- ment, proceed to step 3.

Document jam

Open & Check the blinking cover.

snapped down securely.

Note: If the original document has become wrinkled or torn, do not re-send it.

		Fax Ready			Reserved
6	If this LCD appears, you can continue scanning	Nov 26 2000			13:30
		Fax Ready			Memory 99%
	from the jammed page. If you want to continue,	�
	press [Yes].	�		Continue the		Case
	Note: If you press [No], only scanned pages	�		Storing?
	before the paper jam occurred will be		Yes		No	in
	transmitted or copied.					Just
	Note: If you wish to cancel this operation, press STOP. The machine will

delete all pages from memory and then return to its standby mode. 7 Reset the documents from the jammed page and press START.

5.1