Muratec Fax Machine installation manual How to set the document, Acceptable document size, Started

How to set the document

Acceptable document size

The acceptable dimensions as follows:

• In the Automatic Document Feeder(ADF) • On the Flatbed Scanner(FBS) glass

Feed direction

Automatic document feeder (ADF) (width ⋅ length)

Maximum: 11.0″ ⋅ 17.0″

Minimum: 5.8″ ⋅ 5.0″

Flatbed scanner (FBS) glass (width ⋅ length)

Maximum: 11.0″ ⋅ 17.0″

Things not to put in your fax

To avoid paper jams and damage to your machine, don’t insert:

•Folded, curled, torn, wrinkled or very thin pages

•Documents with staples, glue, tape, paper clips or still-wet correction fluid

•“Sticky notes” (or documents with “sticky notes” attached)

•Cardboard, newspaper or fabric

•Pages with duplicating carbon on either side

•Credit cards or any small, thick items

Getting started

How to set the document
	Started
Setting the documents in the Automatic Document Feeder
1 ment feeder. Your machine’s ADF will hold	Getting
Set your document face up into the docu-

up to 50 sheets.

Note: The green arrow will appear on the ADF cover when the document is set.

2 Adjust the document guide to fit your documents.

Note: If you want to set the different sized documents at a time, turn the Mix Length feature on. (See page 2.18 for copy, or page 3.33 for fax transmis- sion.)

Setting the documents on the FBS glass

1 Lift the platen cover fully.

2 Set your document face down on the FBS glass. The document should be aligned to the rear left corner.

3 Gently close the platen cover.

Note: If you do not lift the platen cover fully, the document size will not be detected automatically.

Important: When copying a bound document, such as a book, the copied image may contain some black areas. To reduce this effect, hold down the document to prevent its bound part from rising. However, do not press too strongly. This may break the FBS glass and cause an injury.

1.19