Teac X-01 D2 Playback, Pausing playback, Stopping playback, Opening and closing the tray

Page 12

Playback

3

 

2

 

4

15

1Turn the unit on.

Each press of the POWER button turns the unit on and off. The ring surrounding the POWER button and the display light up when the unit is turned on.

2Press the OPEN/CLOSE button.

The shutter opens and the disc tray slides out.

<The tray opens after a few seconds (this delay is normal and is due to movement of the VRDS and other mechanisms within the unit).

3Insert the disc, label side up.

<Make sure the disc is centered in the tray in order to avoid any malfunction or jamming of the tray or damage to the disc itself.

4Press the OPEN/CLOSE button again.

The disc tray and shutter close. Take care to avoid pinching your fingers in the moving tray.

<The unit reads the disc, which takes some time due to the reading and storing of the disc’s table of contents.

5Press the PLAY button to start playback.

Pausing playback

Press the PAUSE button to pause playback (the ring surrounding the PAUSE button on the main unit lights).

Press PLAY or PAUSE to restart playback.

Stopping playback

Press the STOP button (the ring surrounding the STOP button on the main unit lights).

Opening and closing the tray

Pressing OPEN/CLOSE opens the tray if it is closed, and closes it if it is open. When the tray is opened during playback, it may take a few seconds before the disc is “unloaded” and the tray opens.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 01 D2 Important Safety Instructions For U.S.AContents Features Before Use Discs Type of Discs That Can be Played on This SystemFollowing discs cannot be played with this unit Remote Control Unit Restoring factory settingsHow to insert the batteries Connection Word sync connector Signal GND connectionPower cord receptacle Analog audio output terminalsFront panel features Front PanelDisplay Understanding the remote control unit Pausing playback PlaybackStopping playback Opening and closing the traySkipping playback Selecting a trackFast scanning Selecting the playback areaProgrammed playback Clearing the last track from the listAdding tracks to the list Clearing the whole programRepeat mode Display dimmingTrack repeat Disc repeatChanging the display mode Word DAC LayerWord Word sync DAC D/A converterDSD Layer priority playback area LinkSacd PCMSettings introduction Exit the setup menu by pressing Setup once moreUse the cursor buttons to navigate the menus Settings Setup Menu Chart Settings Audio Setup Analog output Analog OutDigital output DigitalOut CD DirectSpeaker Size SP Size LargeSmall On subwoofer onlyThis setup is effective in the following case only Speaker distance DistanceSpeaker levels SP Level Test tone length Test toneHow to connect multiple i.LINK-capable devices Link IeeeCopyright protection system Dtcp Data transfer rateTroubleshooting UnlckSpecifications Sommaire Pour l’EuropeMise au rebut de votre ancien appareil Caractéristiques Moteur sans noyau avec aimants néodymeAvant utilisation Disques Types de disques lisibles par ce systèmeCD audio Propos des CD-R/CD-RWTélécommande Remplacement des pilesRestauration des réglages d’usine Comment insérer les pilesConnexions Connexion Signal GND Prises de sortie audio analogiquePrises de sortie audio numérique Prise i.LINK AudioDescription de la face avant Face avantAfficheur Comprendre la télécommande Touches curseur et EnterPavé numérique Lecture Mise en pause de la lectureArrêt de la lecture Ouverture et fermeture du tiroirSaut de lecture Sélection d’une plageRecherche rapide Sélection de la zone de lectureLecture programmée Effacement de la dernière plage de la listeAjout de plages à la liste Effacement de toute la programmationMode Repeat lecture en boucle Atténuation de l’afficheurPlage en boucle Disque en boucleChangement du mode d’affichage Word Synchro Word DAC Convertisseur N/AREF. Référence Bit MultibitLayer zone à lecture prioritaire Encore sur Setup Réglages introductionUtilisez les touches curseur pour naviguer dans les menus Réglages Tableau du menu de configuration Réglages Configuration audio Sortie analogique Analog OutSortie numérique DigitalOut Taille d’enceinte SP Size On caisson de graves seulementDistance des enceintes Distance Niveaux des enceintes SP LevelDurée de la tonalité de test Test tone Sélectionnez « Test Start » et appuyez sur la toucheSystème de protection de droits d’auteur Taux de transfert des donnéesComment connecter plusieurs appareils compatibles i.LINK Connexion en guirlandeGuide de dépannage UNLCK! »Spécifications Inhalt Ausstattungsmerkmale Kernloser Motor mit Neodym-MagnetenStabiles Chassis mit drei punktgelagerten Standfüßen Unübertroffene Ausstattungsmerkmale Audio-DACsWord Clock Synchronisation Vor der ersten Inbetriebnahme LieferumfangHinweise zur Verwendung dieser Bedienungsanleitung Vor der ersten InbetriebnahmeAufstellen des X-01 D2 AchtungZur Wiedergabe mit dem X-01 D2 geeignete Disc-Formate Allgemeines zu CD-R/CD-RWsAchtung WarnungAnfassen einer Disc Anschlüsse Signal GND Signalmasseanschluss Analoge AudioausgängeDigitale Audioausgänge LINK-Schnittstelle AudioFernbedienung Einsetzen von BatterienBatteriewechsel Vorsichtsmaßnahmen im Umgang mit BatterienBedienelemente auf der Gerätevorderseite DAC-AnzeigeFernbedienungssensor Display Disc-Schublade und VerschlussVerwenden der Fernbedienung ZifferntastenPlay Area Wiedergabebereich Cursor-Tasten und EnterDisplay Wiedergabe Unterbrechen der Wiedergabe PauseBeenden der Wiedergabe Öffnen und Schließen der Disc-SchubladeVerwenden der SKIP-Tasten Auswählen eines MusiktitelsSchneller Suchlauf Wiedergabe einer programmierten Titelfolge Löschen des letzten Titels einer ListeTitel zu einer Liste hinzufügen Löschen einer kompletten TitelfolgeWiedergabewiederholung Einstellen der Display-HelligkeitWiedergabewiederholung von Musiktiteln Wiedergabewiederholung aller TitelÄndern der Displayanzeige NormalanzeigeDAC D/A-Wandler REF. ReferenzBit 1-Bit Layer bevorzugter Wiedergabebereich Einstellungen Einleitung Einstellungen Setup-Menü-Diagramm Einstellungen Audio Setup Analogausgang Analog OutDigitalausgang DigitalOut Abmessungen der Lautsprecherboxen SP Size Large großSmall klein On nur SubwooferDauer des Testtonsignals Test tone Abstand der Lautsprechersysteme zur Hörposition DistanceLautsprecher-Wiedergabepegel SP Level Kopierschutzsystem Dtcp DatenübertragungsrateAnschließen mehrerer i.LINK-kompatibler Komponenten HinweiseTechnische Daten Hilfe bei Funktionsstörungen Vermeiden Sie Kondensationsbildung Pflege und WartungTeac Esoteric Company

X-01 D2 specifications

The Teac X-01 D2 is a premier audio component that has garnered attention among audiophiles and music enthusiasts. Designed with a keen focus on sound quality and advanced technology, it is celebrated for its exceptional playback capabilities and versatile features.

At its core, the Teac X-01 D2 is a high-end CD player that seamlessly combines modern digital advancements with classic analog design principles. It features a high-precision, slot-loading disc mechanism that not only enhances the convenience of use but also contributes to minimized vibrations during playback. This ensures that the audio signal remains clean and unaffected, resulting in superior sound quality.

One of the standout features of the X-01 D2 is its Dual-DAC architecture, utilizing two high-performance Digital-to-Analog Converters. This design allows for greater detail and dynamic range in audio playback, providing listeners with a rich and immersive experience. The unit supports various audio formats, including standard CDs, as well as high-resolution audio files, ensuring that users can enjoy their music in the utmost fidelity.

The incorporation of TEAC's proprietary technologies also elevates the performance of the X-01 D2. The Ultra-Linear Circuitry minimizes noise and distortion, while the high-quality, low-jitter clock circuitry ensures accurate signal processing. As a result, the audio produced is remarkably clear and precise, showcasing the nuances in even the most complex musical pieces.

Additionally, the Teac X-01 D2 includes multiple digital outputs, allowing users the flexibility to connect to a range of audio systems. These outputs include AES/EBU, coaxial, and optical connections, making it compatible with various audio equipment. The unit also features an analog output, providing connection options for those who prefer a classic analog connection to their amplifiers.

User-friendly controls and an intuitive interface further enhance the overall experience with the X-01 D2. Users can easily navigate through their music collection, adjusting settings and playback modes with ease. Its sleek design, complemented by a high-quality build, ensures that it fits seamlessly into any audio setup, both aesthetically and functionally.

In summary, the Teac X-01 D2 stands as a testament to the brand's commitment to quality and innovation. With its advanced technologies and features, it delivers an unparalleled listening experience that is sure to satisfy even the most discerning audio enthusiasts.
Top Page Image Contents