Fujitsu E600 user manual Xii

Page 12

Warning and caution labels

Your PC bears the warning and caution labels as shown below. The warning and caution labels must not be removed or damaged.

Rear of the PC main unit

DESKPOWER E600

MODEL : DT4

	NRTL/C
100-127V (6.0A) /200-240V (3.0A) 50/60Hz	162874
100-127V (6.0A) /200-240V (3.0A) 50/60Hz

MADE IN SINGAPORE

By Fujitsu Limited, Japan (M)

WARNING

Electric shock

To prevent electric shock, switch off the PC and connected peripherals and unplug power cords from respective outlets before disassembling the unit and installing a built-in option.

Inside the PC main unit

WARNING

Electric shock To prevent electric shock and/or fire, do

not remove the cover of this unit, which includes a high voltage section.

ATTENTION

115V of voltage switch in the power supply corresponds to 100-127V 230V of voltage switch in the power supply corresponds to 200-240V

WARNING

• Before mounting or dismounting an optional unit in/from your PC, switch off the PC and all connected units and unplug all power cords from respective outlets to prevent electric shock.

xii

Image 12

Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Conventions Used in This Manual IntroductionNotational conventions Safety Important NotesManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorCleaning the keyboard and the mouse Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionXvi Chapter Steps for Initial Setup Preparing for UseUnpacking and Checking the Delivery External devicesSetting Up the PC Vertical operating positionPage Connecting the monitor Connecting standard keyboardConnect the Monitor, Mouse and Keyboard Connecting the mouse Connecting the keyboardConnecting a PS/2 mouse Connecting USB mouseConnecting the PC to the Mains Voltage Initial Switch-on Software will be Installed Switching on monitor and PCConnecting External Devices Installing the softwareConnecting cables Disconnecting cablesLAN Ports on the PCConnecting external devices to the serial port Connecting external devices to the parallel portSettings of the serial port Settings of the parallel portConnecting external devices to the USB ports Operation Switching On the PC Switching Off the PCOperation Indicators On the PC CD-ROM indicatorFloppy disk indicator SmartCard reader indicatorPower-on indicator Hard disk indicatorSettings in Bios Setup Property and Data ProtectionUnlocking and Locking Casing Locking the casingBios Setup Security Functions Anti-theft Protection and Lead-sealingTroubleshooting Tips Troubleshooting and Tips Installing New SoftwareMains voltage supply is faulty Internal power supply overloadedScreen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Window XP Wrong RAM modules have been insertedError Messages on the Screen Restoring the Hard Disk ContentsTime and/or Date is not Correct TipsPage System Expansion System Expansion Information about BoardsOpening the Casing Closing the Casing Installing and Removing a Board Installing board bracketRemoving board bracket Installing a board Make the required settings for the boardPage Removing a board Page Low-Profile Boards Mounting slot adapterRemoving slot adapter Installing and Removing the Graphics Card Installing the graphics cardRemoving the graphics card Installing and Removing Drives Replacing Drive in 51/2 inch BayIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Technical Data Electrical Data