Fujitsu E600 user manual Folding Up and Down the Drive Cage

Page 55

Folding Up and Down the Drive Cage

￿Open the casing (see "Opening the casing").

Please also observe the sticker on the drive cage.

￿Folding up the drive cage

3

2

1Disconnect the cables from the floppy disk drive (1).

2Press on the drive cage lever (2).

3Fold the drive cage completely upward in the direction of the arrow (3).

￿Folding down the drive cage

5

4

1Press on the locking lug (4) of the drive cage and then fold the drive cage with light pressure in the direction of the arrow (5) until the lever engages. Make sure that no cables are pinched in the process.

2Connect the cables to the floppy disk drive.

39

Image 55
Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Introduction Conventions Used in This ManualNotational conventions Energy saving SafetyImportant Notes Manufacturer’s notesFCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Cleaning the keyboard and the mouseReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansion Technical DataXvi Chapter External devices Steps for Initial SetupPreparing for Use Unpacking and Checking the DeliveryVertical operating position Setting Up the PCPage Connecting standard keyboard Connecting the monitorConnect the Monitor, Mouse and Keyboard Connecting USB mouse Connecting the mouseConnecting the keyboard Connecting a PS/2 mouseConnecting the PC to the Mains Voltage Switching on monitor and PC Initial Switch-on Software will be InstalledDisconnecting cables Connecting External DevicesInstalling the software Connecting cablesPorts on the PC LANSettings of the parallel port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the serial portConnecting external devices to the USB ports Operation Switching Off the PC Switching On the PCOperation SmartCard reader indicator Indicators On the PCCD-ROM indicator Floppy disk indicatorHard disk indicator Power-on indicatorLocking the casing Settings in Bios SetupProperty and Data Protection Unlocking and Locking CasingAnti-theft Protection and Lead-sealing Bios Setup Security FunctionsTroubleshooting Tips Internal power supply overloaded Troubleshooting and TipsInstalling New Software Mains voltage supply is faultyScreen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XPTips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System ExpansionOpening the Casing Closing the Casing Installing board bracket Installing and Removing a BoardRemoving board bracket Make the required settings for the board Installing a boardPage Removing a board Page Mounting slot adapter Low-Profile BoardsRemoving slot adapter Installing the graphics card Installing and Removing the Graphics CardRemoving the graphics card Replacing Drive in 51/2 inch Bay Installing and Removing DrivesIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Electrical Data Technical Data