Fujitsu E600 user manual Connect the Monitor, Mouse and Keyboard, Connecting the monitor

Page 21

Connect the Monitor, Mouse and Keyboard

The ports for monitor, mouse and keyboard are on the rear and front (USB ports) of the PC.

Keyboard port / purple

PS/2 mouse port / green

Monitor port / blue

USB port / black

Connecting the monitor

Connecting standard keyboard

1Follow the instructions contained in the monitor manual to prepare the monitor for operation (e.g. connecting cables).

2 Plug the data cable into the monitor port

of the PC.

2

1

3Depending on the connector, plug the monitor's power cable into either the PC (1) or a grounded mains outlet (2).

We recommend to connect the monitor power cable to the server monitor socket. The monitor is then switched off automatically when you switch the PC off.

CAUTION

The monitor power cable may only be connected to the PC monitor socket if the monitor current consumption is smaller than 1,5 A with 230 V or 3 A with 115 V. The values for the monitor current consumption can be found in the technical data on the monitor or in the operating manual for the monitor.

5

Image 21
Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Conventions Used in This Manual IntroductionNotational conventions Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCCleaning the keyboard and the mouse Transporting the PCReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansion Technical DataXvi Chapter Preparing for Use Steps for Initial SetupUnpacking and Checking the Delivery External devicesVertical operating position Setting Up the PCPage Connecting the monitor Connecting standard keyboardConnect the Monitor, Mouse and Keyboard Connecting the keyboard Connecting the mouseConnecting a PS/2 mouse Connecting USB mouseConnecting the PC to the Mains Voltage Switching on monitor and PC Initial Switch-on Software will be InstalledInstalling the software Connecting External DevicesConnecting cables Disconnecting cablesPorts on the PC LANConnecting external devices to the parallel port Connecting external devices to the serial portSettings of the serial port Settings of the parallel portConnecting external devices to the USB ports Operation Switching On the PC Switching Off the PCOperation CD-ROM indicator Indicators On the PCFloppy disk indicator SmartCard reader indicatorHard disk indicator Power-on indicatorProperty and Data Protection Settings in Bios SetupUnlocking and Locking Casing Locking the casingAnti-theft Protection and Lead-sealing Bios Setup Security FunctionsTroubleshooting Tips Installing New Software Troubleshooting and TipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the Hard Disk Contents Error Messages on the ScreenTime and/or Date is not Correct TipsPage System Expansion Information about Boards System ExpansionOpening the Casing Closing the Casing Installing and Removing a Board Installing board bracketRemoving board bracket Make the required settings for the board Installing a boardPage Removing a board Page Low-Profile Boards Mounting slot adapterRemoving slot adapter Installing the graphics card Installing and Removing the Graphics CardRemoving the graphics card Installing and Removing Drives Replacing Drive in 51/2 inch BayIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Electrical Data Technical Data