Fujitsu E600 user manual

Page 49

4Push the slot cover into the slot in the direction of the arrow. Ensure that the point of the slot cover engages on the outside of the board bracket.

5Fold up the retaining bracket again so that it engages.

CAUTION

For cooling, protection against fire, and in order to comply with EMC (electromagnetic compatibility) regulations, you must refit the slot cover.

If you have installed or removed a PCI board, please check the relevant PCI slot settings in the BIOS Setup. If necessary, change the settings. Further information is provided in the PCI board documentation.

The upper slot is suitable for low-profile cards with an adapter.

33

Image 49
Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Introduction Conventions Used in This ManualNotational conventions Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCCleaning the keyboard and the mouse Transporting the PCReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansion Technical DataXvi Chapter Preparing for Use Steps for Initial SetupUnpacking and Checking the Delivery External devicesVertical operating position Setting Up the PCPage Connecting standard keyboard Connecting the monitorConnect the Monitor, Mouse and Keyboard Connecting the keyboard Connecting the mouseConnecting a PS/2 mouse Connecting USB mouseConnecting the PC to the Mains Voltage Switching on monitor and PC Initial Switch-on Software will be InstalledInstalling the software Connecting External DevicesConnecting cables Disconnecting cablesPorts on the PC LANConnecting external devices to the parallel port Connecting external devices to the serial portSettings of the serial port Settings of the parallel portConnecting external devices to the USB ports Operation Switching Off the PC Switching On the PCOperation CD-ROM indicator Indicators On the PCFloppy disk indicator SmartCard reader indicatorHard disk indicator Power-on indicatorProperty and Data Protection Settings in Bios SetupUnlocking and Locking Casing Locking the casingAnti-theft Protection and Lead-sealing Bios Setup Security FunctionsTroubleshooting Tips Installing New Software Troubleshooting and TipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the Hard Disk Contents Error Messages on the ScreenTime and/or Date is not Correct TipsPage System Expansion Information about Boards System ExpansionOpening the Casing Closing the Casing Installing board bracket Installing and Removing a BoardRemoving board bracket Make the required settings for the board Installing a boardPage Removing a board Page Mounting slot adapter Low-Profile BoardsRemoving slot adapter Installing the graphics card Installing and Removing the Graphics CardRemoving the graphics card Replacing Drive in 51/2 inch Bay Installing and Removing DrivesIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Electrical Data Technical Data