Fujitsu E600 user manual Connecting the PC to the Mains Voltage

Page 23

Connecting the PC to the Mains Voltage

1

100 V - 127 V

115 230

1

200 V - 240 V

230 115

1= Notch for inserting the screwdriver 3 Check the voltage setting.

CAUTION

The value indicated with an arrow must be compatible with the local rated voltage:

115 = 100 V to 127 V

230 = 200 V to 240 V

If the voltage setting is incorrect, then lift out the manual voltage adjuster with a screwdriver (1), turn it to the required setting and reinsert it.

2

1

3Connect the power cable to the PC (1).

3Plug the power plug into a grounded mains outlet (2).

7

Image 23
Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Notational conventions Conventions Used in This ManualIntroduction Energy saving SafetyImportant Notes Manufacturer’s notesFCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Cleaning the keyboard and the mouseReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansion Technical DataXvi Chapter External devices Steps for Initial SetupPreparing for Use Unpacking and Checking the DeliveryVertical operating position Setting Up the PCPage Connect the Monitor, Mouse and Keyboard Connecting the monitorConnecting standard keyboard Connecting USB mouse Connecting the mouseConnecting the keyboard Connecting a PS/2 mouseConnecting the PC to the Mains Voltage Switching on monitor and PC Initial Switch-on Software will be InstalledDisconnecting cables Connecting External DevicesInstalling the software Connecting cablesPorts on the PC LANSettings of the parallel port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the serial portConnecting external devices to the USB ports Operation Operation Switching On the PCSwitching Off the PC SmartCard reader indicator Indicators On the PCCD-ROM indicator Floppy disk indicatorHard disk indicator Power-on indicatorLocking the casing Settings in Bios SetupProperty and Data Protection Unlocking and Locking CasingAnti-theft Protection and Lead-sealing Bios Setup Security FunctionsTroubleshooting Tips Internal power supply overloaded Troubleshooting and TipsInstalling New Software Mains voltage supply is faultyScreen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XPTips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System ExpansionOpening the Casing Closing the Casing Removing board bracket Installing and Removing a BoardInstalling board bracket Make the required settings for the board Installing a boardPage Removing a board Page Removing slot adapter Low-Profile BoardsMounting slot adapter Installing the graphics card Installing and Removing the Graphics CardRemoving the graphics card IDE drives and serial ATA drives Installing and Removing DrivesReplacing Drive in 51/2 inch Bay Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Electrical Data Technical Data