Fujitsu E600 user manual Lan, Ports on the PC

Page 26

Ports on the PC

The ports for external devices are on the rear and on the front of the PC. The ports available on your PC depend on the configuration level you have selected. The standard ports are marked with the symbols shown below (or similar).

Keyboard port, purple

PS/2 mouse port, green

1

Serial port 1, teal or turquoise

2

Serial port 2, teal or turquoise

Monitor port, blue

Parallel port / Printer, burgundy

Headphones port, light green

Microphone jack (mono), pink

Audio output (Line out), lime green

Audio input (Line in), light blue

USB - Universal Serial Bus, black

LAN

LAN connector

Some of the devices that you connect require special drivers (see the operating system and device documentation).

10

Image 26

Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Notational conventions Conventions Used in This ManualIntroduction Manufacturer’s notes SafetyImportant Notes Energy savingFCC Class B Compliance Statement Cleaning the keyboard and the mouse Cleaning the PCCleaning the system unit and the monitor Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionXvi Chapter Unpacking and Checking the Delivery Steps for Initial SetupPreparing for Use External devicesSetting Up the PC Vertical operating positionPage Connect the Monitor, Mouse and Keyboard Connecting the monitorConnecting standard keyboard Connecting a PS/2 mouse Connecting the mouseConnecting the keyboard Connecting USB mouseConnecting the PC to the Mains Voltage Initial Switch-on Software will be Installed Switching on monitor and PCConnecting cables Connecting External DevicesInstalling the software Disconnecting cablesLAN Ports on the PCSettings of the serial port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the parallel portConnecting external devices to the USB ports Operation Operation Switching On the PCSwitching Off the PC Floppy disk indicator Indicators On the PCCD-ROM indicator SmartCard reader indicatorPower-on indicator Hard disk indicatorUnlocking and Locking Casing Settings in Bios SetupProperty and Data Protection Locking the casingBios Setup Security Functions Anti-theft Protection and Lead-sealingTroubleshooting Tips Mains voltage supply is faulty Troubleshooting and TipsInstalling New Software Internal power supply overloadedScreen stays blank Wrong monitor has been set under Window XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been insertedTime and/or Date is not Correct Error Messages on the ScreenRestoring the Hard Disk Contents TipsPage System Expansion System Expansion Information about BoardsOpening the Casing Closing the Casing Removing board bracket Installing and Removing a BoardInstalling board bracket Installing a board Make the required settings for the boardPage Removing a board Page Removing slot adapter Low-Profile BoardsMounting slot adapter Installing and Removing the Graphics Card Installing the graphics cardRemoving the graphics card IDE drives and serial ATA drives Installing and Removing DrivesReplacing Drive in 51/2 inch Bay Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Technical Data Electrical Data