Fujitsu E600 user manual Connecting external devices to the USB ports

Page 28

Connecting external devices to the USB ports

You can connect a wide range of external devices to the USB port (e.g. printer, scanner, modem or keyboard).

USB devices are hot-pluggable. This allows cables from USB devices to be connected and disconnected with the system switched on.

Additional information can be found in the documentation for the USB devices.

Connect the data cable to the external device.

Connect the data cable to the USB port .

Device drivers

The devices you connect to the USB ports usually require no driver of their own, as the required software is already included in the operating system. However, if the USB device requires its own software, please install it from the data carrier provided with the USB device.

12

Image 28

Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Introduction Conventions Used in This ManualNotational conventions Safety Important NotesManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorCleaning the keyboard and the mouse Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionXvi Chapter Steps for Initial Setup Preparing for UseUnpacking and Checking the Delivery External devicesSetting Up the PC Vertical operating positionPage Connecting standard keyboard Connecting the monitorConnect the Monitor, Mouse and Keyboard Connecting the mouse Connecting the keyboardConnecting a PS/2 mouse Connecting USB mouseConnecting the PC to the Mains Voltage Initial Switch-on Software will be Installed Switching on monitor and PCConnecting External Devices Installing the softwareConnecting cables Disconnecting cablesLAN Ports on the PCConnecting external devices to the serial port Connecting external devices to the parallel portSettings of the serial port Settings of the parallel portConnecting external devices to the USB ports Operation Switching Off the PC Switching On the PCOperation Indicators On the PC CD-ROM indicatorFloppy disk indicator SmartCard reader indicatorPower-on indicator Hard disk indicatorSettings in Bios Setup Property and Data ProtectionUnlocking and Locking Casing Locking the casingBios Setup Security Functions Anti-theft Protection and Lead-sealingTroubleshooting Tips Troubleshooting and Tips Installing New SoftwareMains voltage supply is faulty Internal power supply overloadedScreen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Window XP Wrong RAM modules have been insertedError Messages on the Screen Restoring the Hard Disk ContentsTime and/or Date is not Correct TipsPage System Expansion System Expansion Information about BoardsOpening the Casing Closing the Casing Installing board bracket Installing and Removing a BoardRemoving board bracket Installing a board Make the required settings for the boardPage Removing a board Page Mounting slot adapter Low-Profile BoardsRemoving slot adapter Installing and Removing the Graphics Card Installing the graphics cardRemoving the graphics card Replacing Drive in 51/2 inch Bay Installing and Removing DrivesIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Technical Data Electrical Data