Fujitsu E600 user manual Installing and Removing the Graphics Card, Installing the graphics card

Page 51

■Installing and Removing the Graphics Card

Your device has a special slot for graphics cards.

Installing the graphics card

1 Open the casing (see "Opening the casing" chapter).

2 Remove the board bracket as described in "Removing board bracket" section.

3Press sideways against the retaining bracket and fold it up in the direction of the arrow

(1).

4Pull the slot cover out of the slot in the direction of the arrow (2).

5Push the board up to its slot (1) in the direction of the arrow as far as the stop.

6Press the board into the slot so that it engages.

7Fold the retaining bracket down again in the direction of the arrow (2). Ensure that the retaining bracket engages.

8Install the board bracket as described in "Installing board bracket" section.

9Close the casing (see "Closing the casing" chapter).

35

Image 51

Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Conventions Used in This Manual IntroductionNotational conventions Energy saving SafetyImportant Notes Manufacturer’s notesFCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Cleaning the keyboard and the mouseReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansion Technical DataXvi Chapter External devices Steps for Initial SetupPreparing for Use Unpacking and Checking the DeliveryVertical operating position Setting Up the PCPage Connecting the monitor Connecting standard keyboardConnect the Monitor, Mouse and Keyboard Connecting USB mouse Connecting the mouseConnecting the keyboard Connecting a PS/2 mouseConnecting the PC to the Mains Voltage Switching on monitor and PC Initial Switch-on Software will be InstalledDisconnecting cables Connecting External DevicesInstalling the software Connecting cablesPorts on the PC LANSettings of the parallel port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the serial portConnecting external devices to the USB ports Operation Switching On the PC Switching Off the PCOperation SmartCard reader indicator Indicators On the PCCD-ROM indicator Floppy disk indicatorHard disk indicator Power-on indicatorLocking the casing Settings in Bios SetupProperty and Data Protection Unlocking and Locking CasingAnti-theft Protection and Lead-sealing Bios Setup Security FunctionsTroubleshooting Tips Internal power supply overloaded Troubleshooting and TipsInstalling New Software Mains voltage supply is faultyScreen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XPTips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System ExpansionOpening the Casing Closing the Casing Installing and Removing a Board Installing board bracketRemoving board bracket Make the required settings for the board Installing a boardPage Removing a board Page Low-Profile Boards Mounting slot adapterRemoving slot adapter Installing the graphics card Installing and Removing the Graphics CardRemoving the graphics card Installing and Removing Drives Replacing Drive in 51/2 inch BayIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Electrical Data Technical Data