Fujitsu E600 user manual Power-on indicator, Hard disk indicator

Page 32

4Power-on indicator

–The indicator lights green: The PC is on.

–The indicator lights orange:

The PC is in energy-saving mode. After being switched on the PC or returns to the state it was in before the energy-saving mode.

CAUTION

In an energy-saving mode the PC must not be switched off with the power switch or disconnected from the mains supply, as this may result in data loss.

–The indicator does not light up:

The PC is switched off (power switch at 0 or disconnected from the power supply) or ready- to-operate. If the PC is ready-to-operate, the PC can be enabled with the ON/OFF switch.

5Hard disk indicator

The indicator lights up when the hard disk drive of the PC is accessed.

16

Image 32

Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Notational conventions Conventions Used in This ManualIntroduction Safety Important NotesManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorCleaning the keyboard and the mouse Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionXvi Chapter Steps for Initial Setup Preparing for UseUnpacking and Checking the Delivery External devicesSetting Up the PC Vertical operating positionPage Connect the Monitor, Mouse and Keyboard Connecting the monitorConnecting standard keyboard Connecting the mouse Connecting the keyboardConnecting a PS/2 mouse Connecting USB mouseConnecting the PC to the Mains Voltage Initial Switch-on Software will be Installed Switching on monitor and PCConnecting External Devices Installing the softwareConnecting cables Disconnecting cablesLAN Ports on the PCConnecting external devices to the serial port Connecting external devices to the parallel portSettings of the serial port Settings of the parallel portConnecting external devices to the USB ports Operation Operation Switching On the PCSwitching Off the PC Indicators On the PC CD-ROM indicatorFloppy disk indicator SmartCard reader indicatorPower-on indicator Hard disk indicatorSettings in Bios Setup Property and Data ProtectionUnlocking and Locking Casing Locking the casingBios Setup Security Functions Anti-theft Protection and Lead-sealingTroubleshooting Tips Troubleshooting and Tips Installing New SoftwareMains voltage supply is faulty Internal power supply overloadedScreen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Window XP Wrong RAM modules have been insertedError Messages on the Screen Restoring the Hard Disk ContentsTime and/or Date is not Correct TipsPage System Expansion System Expansion Information about BoardsOpening the Casing Closing the Casing Removing board bracket Installing and Removing a BoardInstalling board bracket Installing a board Make the required settings for the boardPage Removing a board Page Removing slot adapter Low-Profile BoardsMounting slot adapter Installing and Removing the Graphics Card Installing the graphics cardRemoving the graphics card IDE drives and serial ATA drives Installing and Removing DrivesReplacing Drive in 51/2 inch Bay Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Technical Data Electrical Data