Fujitsu E600 user manual Installing a board, Make the required settings for the board

Page 46

Installing a board

1 Make the required settings for the board.

CAUTION

Do not dispose of the slot cover. For cooling, protection against fire and in order to comply with EMC regulations, you must refit the slot cover if you remove the board.

2 Press on the retaining bracket in the direction of the arrow and fold it down.

3 Pull the slot cover out of the slot in the direction of the arrow.

30

Image 46

Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Introduction Conventions Used in This ManualNotational conventions Manufacturer’s notes SafetyImportant Notes Energy savingFCC Class B Compliance Statement Cleaning the keyboard and the mouse Cleaning the PCCleaning the system unit and the monitor Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionXvi Chapter Unpacking and Checking the Delivery Steps for Initial SetupPreparing for Use External devicesSetting Up the PC Vertical operating positionPage Connecting standard keyboard Connecting the monitorConnect the Monitor, Mouse and Keyboard Connecting a PS/2 mouse Connecting the mouseConnecting the keyboard Connecting USB mouseConnecting the PC to the Mains Voltage Initial Switch-on Software will be Installed Switching on monitor and PCConnecting cables Connecting External DevicesInstalling the software Disconnecting cablesLAN Ports on the PCSettings of the serial port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the parallel portConnecting external devices to the USB ports Operation Switching Off the PC Switching On the PCOperation Floppy disk indicator Indicators On the PCCD-ROM indicator SmartCard reader indicatorPower-on indicator Hard disk indicatorUnlocking and Locking Casing Settings in Bios SetupProperty and Data Protection Locking the casingBios Setup Security Functions Anti-theft Protection and Lead-sealingTroubleshooting Tips Mains voltage supply is faulty Troubleshooting and TipsInstalling New Software Internal power supply overloadedScreen stays blank Wrong monitor has been set under Window XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been insertedTime and/or Date is not Correct Error Messages on the ScreenRestoring the Hard Disk Contents TipsPage System Expansion System Expansion Information about BoardsOpening the Casing Closing the Casing Installing board bracket Installing and Removing a BoardRemoving board bracket Installing a board Make the required settings for the boardPage Removing a board Page Mounting slot adapter Low-Profile BoardsRemoving slot adapter Installing and Removing the Graphics Card Installing the graphics cardRemoving the graphics card Replacing Drive in 51/2 inch Bay Installing and Removing DrivesIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Technical Data Electrical Data