Fujitsu E600 user manual Installing and Removing Drives, Replacing Drive in 51/2 inch Bay

Page 53

■Installing and Removing Drives

In the standard model the PC may be equipped with the following drives:

One accessible 31/2 inch drive (floppy drive)

One non-accessible 31/2 inch drive (hard disk)

One accessible 51/4 inch drive (e.g. DVD or CD ROM drive)

or:

One accessible 31/2 inch drive (floppy drive)

Two non-accessible 31/2 inch drive (hard disk)

"Accessible drives" are e.g. DVD or CD ROM drives, into which a data carrier can be inserted from outside. Non-accessible drives are e.g. hard disk drives.

IDE drives and serial ATA drives

By default IDE drives and serial ATA drives are supported.

■Replacing Drive in 51/2 inch Bay

Open the casing (see "Opening the casing" chapter).

Removing a drive

1 Pull the data and the power supply connectors from the desired drive.

2Press the EasyChange rails (1) together and pull the drive out of the casing (2).

3Remove the EasyChange rails from the drive.

If your PC is equipped with a drive carrier instead of the drive, you can remove and install the carrier in the same way.

37

Image 53

Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Notational conventions Conventions Used in This ManualIntroduction Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCCleaning the keyboard and the mouse Transporting the PCReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansion Technical DataXvi Chapter Preparing for Use Steps for Initial SetupUnpacking and Checking the Delivery External devicesVertical operating position Setting Up the PCPage Connect the Monitor, Mouse and Keyboard Connecting the monitorConnecting standard keyboard Connecting the keyboard Connecting the mouseConnecting a PS/2 mouse Connecting USB mouseConnecting the PC to the Mains Voltage Switching on monitor and PC Initial Switch-on Software will be InstalledInstalling the software Connecting External DevicesConnecting cables Disconnecting cablesPorts on the PC LANConnecting external devices to the parallel port Connecting external devices to the serial portSettings of the serial port Settings of the parallel portConnecting external devices to the USB ports Operation Operation Switching On the PCSwitching Off the PC CD-ROM indicator Indicators On the PCFloppy disk indicator SmartCard reader indicatorHard disk indicator Power-on indicatorProperty and Data Protection Settings in Bios SetupUnlocking and Locking Casing Locking the casingAnti-theft Protection and Lead-sealing Bios Setup Security FunctionsTroubleshooting Tips Installing New Software Troubleshooting and TipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the Hard Disk Contents Error Messages on the ScreenTime and/or Date is not Correct TipsPage System Expansion Information about Boards System ExpansionOpening the Casing Closing the Casing Removing board bracket Installing and Removing a BoardInstalling board bracket Make the required settings for the board Installing a boardPage Removing a board Page Removing slot adapter Low-Profile BoardsMounting slot adapter Installing the graphics card Installing and Removing the Graphics CardRemoving the graphics card IDE drives and serial ATA drives Installing and Removing DrivesReplacing Drive in 51/2 inch Bay Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Electrical Data Technical Data