Fujitsu E600 user manual Indicators On the PC, CD-ROM indicator, Floppy disk indicator

Page 31

Indicators On the PC

The indicators are on the front of the PC. Which indicators are available on your PC depends on the configuration level you have selected.

4 5

3

2

1

1= CD-ROM indicator

2= Floppy disk indicator

3= SmartCard reader indicator

4= Power-on indicator

5= Hard disk indicator

1CD-ROM indicator

The indicator lights up when the CD-ROM drive is accessed. You may only remove the CD when the indicator is dark.

2Floppy disk indicator

The indicator lights up when the floppy disk drive of the PC is accessed. You may only remove the floppy disk when the indicator is unlit.

3SmartCard reader indicator

The indicator lights up when the SmartCard reader is ready-to-use. The indicator flashes when the SmartCard is accessed.

15

Image 31

Contents Deskpower E600 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Introduction Conventions Used in This ManualNotational conventions Energy saving SafetyImportant Notes Manufacturer’s notesFCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Cleaning the keyboard and the mouseReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansion Technical DataXvi Chapter External devices Steps for Initial SetupPreparing for Use Unpacking and Checking the DeliveryVertical operating position Setting Up the PCPage Connecting standard keyboard Connecting the monitorConnect the Monitor, Mouse and Keyboard Connecting USB mouse Connecting the mouseConnecting the keyboard Connecting a PS/2 mouseConnecting the PC to the Mains Voltage Switching on monitor and PC Initial Switch-on Software will be InstalledDisconnecting cables Connecting External DevicesInstalling the software Connecting cablesPorts on the PC LANSettings of the parallel port Connecting external devices to the serial portConnecting external devices to the parallel port Settings of the serial portConnecting external devices to the USB ports Operation Switching Off the PC Switching On the PCOperation SmartCard reader indicator Indicators On the PCCD-ROM indicator Floppy disk indicatorHard disk indicator Power-on indicatorLocking the casing Settings in Bios SetupProperty and Data Protection Unlocking and Locking CasingAnti-theft Protection and Lead-sealing Bios Setup Security FunctionsTroubleshooting Tips Internal power supply overloaded Troubleshooting and TipsInstalling New Software Mains voltage supply is faultyScreen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XPTips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System ExpansionOpening the Casing Closing the Casing Installing board bracket Installing and Removing a BoardRemoving board bracket Make the required settings for the board Installing a boardPage Removing a board Page Mounting slot adapter Low-Profile BoardsRemoving slot adapter Installing the graphics card Installing and Removing the Graphics CardRemoving the graphics card Replacing Drive in 51/2 inch Bay Installing and Removing DrivesIDE drives and serial ATA drives Close the casing see Closing the casing chapter Folding Up and Down the Drive Cage Changing the Floppy Disk Drive Replacing a Hard Disk Drive Page Page Replacing Lithium Battery Technical Data Electrical Data Technical Data