Fujitsu E623 user manual Xii

Page 12

Warning and Caution Labels

Your PC bears the warning and caution labels as shown below. The warning and caution labels must not be removed or damaged.

Rear of the PC main unit

DESKPOWER E623

MODEL FPC–E623

NRTL/C

100-127V (8.0A) /200-240V (4.0A) 50/60Hz

MADE IN SINGAPORE

By Fujitsu Limited, Japan (M)

WARNING

Electric shock

To prevent electric shock, switch off the PC and connected peripherals and unplug power cords from respective outlets before disassembling the unit and installing a built-in option.

Inside the PC main unit

WARNING

Electric shock To prevent electric shock and/or fire, do

not remove the cover of this unit, which includes a high voltage section.

WARNING

• Before mounting or dismounting an optional unit in/from your PC, switch off the PC and all connected units and unplug all power cords from respective outlets to prevent electric shock.

xii

Image 12

Contents Deskpower E623 User’s Manual Important Safety Instructions Iii Before Reading this Manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Conventions Used in this Manual IntroductionNotational conventions Safety Important NotesManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorTransporting the PC Disposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Chapter Steps for Initial Setup Unpacking and Checking the DeliveryExternal devices Drives and boardsSetting Up the PC Installing the FeetWhen two feet double are used Vertical positioningWhen one foot single is used Horizontal positioning Point Initial Switch-on Software will be Installed Switching on monitor and PCOperation Switching On the PC Switching Off the PCPower indicator Front Panels of the Main Unit of the Personal ComputerVent Smart card bayDisc access indicator Floppy disk access indicatorCD access indicator Microphone jackBack Panel of the Main Unit of the Personal Computer AGP card slot Antitheft lockKey hole for a padlock Expansion card slotMain switch OutletInlet LAN portCheck that the upper cover has been firmly installed Anti-theft Protection and Lead-sealingPage Troubleshooting Tips Installing New Software Mains voltage supply is faultyInternal power supply overloaded Screen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Window XP Wrong RAM modules have been insertedError Messages on the Screen Restoring the Hard Disk ContentsTime and/or Date is not Correct TipsPage System Expansion System Expansion Information about BoardsHow to remove the main unit cover Removing the Main Unit CoverInstalling Memory Locations for memory to be installed Memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Locations for expansion cards to be installed Expansion cards to be installedInstalling expansion cards Press and raise the slot cover lock Remove the slot coverInstall the installing fitting Insert the expansion card into the portReplacing Lithium Battery