Fujitsu E623 Front Panels of the Main Unit of the Personal Computer, Vent, Smart card bay

Page 25

Front Panels of the Main Unit of the Personal Computer

12

13

14

15

1

2

3

4

5

6

7

8

9

10

11

1Vent

On the top of the computer there is an opening through which heat is forcibly discharged from the computer. Note that the vent not to be blocked off by placing objects. When installing horizontally, install the computer at a location where its surface with the vent is more than 20 cm away from the wall.

2Smart card bay

Smart card bay is not offered as an option.

3Power indicator

Shows the status of the power to the main unit of the personal computer. Lit in green when the computer is powered.

Lit in orange when the computer is in standby mode (power saving status)

4Power supply button Pressed in the following cases.

￿When the main unit of the personal computer is powered on

￿When the personal computer is in standby status (power saving status)

￿When the personal computer is resumed from standby status

11

Image 25
Contents Deskpower E623 User’s Manual Important Safety Instructions Iii For Safe Operation Before Reading this ManualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Introduction Conventions Used in this ManualNotational conventions Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCTransporting the PC Reference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents Chapter Unpacking and Checking the Delivery Steps for Initial SetupExternal devices Drives and boardsInstalling the Feet Setting Up the PCVertical positioning When two feet double are usedWhen one foot single is used Horizontal positioning Point Switching on monitor and PC Initial Switch-on Software will be InstalledOperation Switching Off the PC Switching On the PCFront Panels of the Main Unit of the Personal Computer Power indicatorVent Smart card bayFloppy disk access indicator Disc access indicatorCD access indicator Microphone jackAGP card slot Antitheft lock Back Panel of the Main Unit of the Personal ComputerKey hole for a padlock Expansion card slotOutlet Main switchInlet LAN portAnti-theft Protection and Lead-sealing Check that the upper cover has been firmly installedPage Troubleshooting Tips Mains voltage supply is faulty Installing New SoftwareInternal power supply overloaded Screen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the Hard Disk Contents Error Messages on the ScreenTime and/or Date is not Correct TipsPage System Expansion Information about Boards System ExpansionRemoving the Main Unit Cover How to remove the main unit coverInstalling Memory Memory to be installed Locations for memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Expansion cards to be installed Locations for expansion cards to be installedPress and raise the slot cover lock Remove the slot cover Installing expansion cardsInsert the expansion card into the port Install the installing fittingReplacing Lithium Battery