Fujitsu E623 user manual Initial Switch-on Software will be Installed, Switching on monitor and PC

Page 22

■Initial Switch-on: Software will be Installed

If the PC is connected to a network, the network protocol is required as well as the user and server details. Contact your network administrator if you have any questions about these settings.

When you switch on your PC for the first time, the supplied software is installed and configured. You should plan some time for this, as this process must not be interrupted.

CAUTION

Once the installation has been started the PC must not be switched off!

During installation the PC may only be rebooted when you are requested to do so!

Otherwise the installation will be not be performed correctly. If a fault occurs during the installation, the contents of the hard disk must be completely restored.

Switching on monitor and PC

●Switch the monitor on.

●Switch the PC on. To do this, follow the instructions below.

1 Unplug your computer.

Main switch

2 Remove the upper cover.

Power button

●Switch the PC on with the main power switch on the back panel.

●Press the ON/OFF switch on the front of the PC.

8

Image 22

Contents Deskpower E623 User’s Manual Important Safety Instructions Iii Before Reading this Manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Introduction Conventions Used in this ManualNotational conventions Manufacturer’s notes SafetyImportant Notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCTransporting the PC Disposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Chapter External devices Steps for Initial SetupUnpacking and Checking the Delivery Drives and boardsSetting Up the PC Installing the FeetWhen two feet double are used Vertical positioningWhen one foot single is used Horizontal positioning Point Initial Switch-on Software will be Installed Switching on monitor and PCOperation Switching On the PC Switching Off the PCVent Power indicatorFront Panels of the Main Unit of the Personal Computer Smart card bayCD access indicator Disc access indicatorFloppy disk access indicator Microphone jackKey hole for a padlock Back Panel of the Main Unit of the Personal ComputerAGP card slot Antitheft lock Expansion card slotInlet Main switchOutlet LAN portCheck that the upper cover has been firmly installed Anti-theft Protection and Lead-sealingPage Troubleshooting Tips Mains voltage supply is faulty Installing New SoftwareInternal power supply overloaded Screen stays blank Wrong monitor has been set under Window XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been insertedTime and/or Date is not Correct Error Messages on the ScreenRestoring the Hard Disk Contents TipsPage System Expansion System Expansion Information about BoardsHow to remove the main unit cover Removing the Main Unit CoverInstalling Memory Memory to be installed Locations for memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Locations for expansion cards to be installed Expansion cards to be installedInstalling expansion cards Press and raise the slot cover lock Remove the slot coverInstall the installing fitting Insert the expansion card into the portReplacing Lithium Battery