Fujitsu E623 user manual Installing the Expansion Card

Page 46

Installing the Expansion Card

￿POINT

￿When installing an expansion card after the purchase, turn off your computer after the setup of Windows, then install it.

WARNING

￿Before installing or removing expansion cards, turn off the computer and connected devices, and unplug the computer.

Otherwise, you might get an electric shock.

￿Before installing or removing expansion cards, allow for sufficient times after turning off and unplugging the computer.

Otherwise, you might get burned.

￿When installing expansion cards, use Fujitsu’s products. Otherwise, it might cause an electronic shock, fire, or failure.

CAUTION

￿When installing or removing expansion cards, do not remove screws other than those specified.

Removing the screws other than specified might cause injuries. Doing so might also cause damage to your computer.

￿ Do not touch the printed board other than areas specified.

Touching might cause injuries. Doing so might also cause damage to your computer.

￿ Do not touch the metal fitting on the back side of the main unit of the personal computer of the mother board. Touching might cause injuries. Doing so might also cause damage to your computer.

32

Image 46
Contents Deskpower E623 User’s Manual Important Safety Instructions Iii Before Reading this Manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Introduction Conventions Used in this ManualNotational conventions Manufacturer’s notes SafetyImportant Notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCTransporting the PC Disposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Chapter External devices Steps for Initial SetupUnpacking and Checking the Delivery Drives and boardsSetting Up the PC Installing the FeetWhen two feet double are used Vertical positioningWhen one foot single is used Horizontal positioning Point Initial Switch-on Software will be Installed Switching on monitor and PCOperation Switching On the PC Switching Off the PCVent Power indicatorFront Panels of the Main Unit of the Personal Computer Smart card bayCD access indicator Disc access indicatorFloppy disk access indicator Microphone jackKey hole for a padlock Back Panel of the Main Unit of the Personal ComputerAGP card slot Antitheft lock Expansion card slotInlet Main switchOutlet LAN portCheck that the upper cover has been firmly installed Anti-theft Protection and Lead-sealingPage Troubleshooting Tips Mains voltage supply is faulty Installing New SoftwareInternal power supply overloaded Screen stays blank Wrong monitor has been set under Window XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been insertedTime and/or Date is not Correct Error Messages on the ScreenRestoring the Hard Disk Contents TipsPage System Expansion System Expansion Information about BoardsHow to remove the main unit cover Removing the Main Unit CoverInstalling Memory Memory to be installed Locations for memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Locations for expansion cards to be installed Expansion cards to be installedInstalling expansion cards Press and raise the slot cover lock Remove the slot coverInstall the installing fitting Insert the expansion card into the portReplacing Lithium Battery