Fujitsu E623 user manual Locations for memory to be installed, Memory to be installed

Page 41

Locations for memory to be installed

To install memory, insert it into the memory slot of the main unit of the personal computer.

DDR1

DDR1

Memory to be installed

When installing additional memory, use Fujitsu recommended parts only.

●Table of combinations of memory

Up to a 2-GB memory can be installed in this computer.

When installing memory, check the following Table for the combination of the memory capacity and slots and install correctly.

DDR1	DDR2	Total capacity
256 MB	–	256 MB
128 MB	128 MB	256 MB
256 MB	256 MB	512 MB
512 MB	512 MB	1 GB
1 GB	1 GB	2 GB

IMPORTANT

Do not install memory other than the combination in this Table.

27

Image 41

Contents Deskpower E623 User’s Manual Important Safety Instructions Iii For Safe Operation Before Reading this ManualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Notational conventions Conventions Used in this ManualIntroduction Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Reference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents Chapter Unpacking and Checking the Delivery Steps for Initial SetupExternal devices Drives and boardsInstalling the Feet Setting Up the PCVertical positioning When two feet double are usedWhen one foot single is used Horizontal positioning Point Switching on monitor and PC Initial Switch-on Software will be InstalledOperation Switching Off the PC Switching On the PCFront Panels of the Main Unit of the Personal Computer Power indicatorVent Smart card bayFloppy disk access indicator Disc access indicatorCD access indicator Microphone jackAGP card slot Antitheft lock Back Panel of the Main Unit of the Personal ComputerKey hole for a padlock Expansion card slotOutlet Main switchInlet LAN portAnti-theft Protection and Lead-sealing Check that the upper cover has been firmly installedPage Troubleshooting Tips Internal power supply overloaded Installing New SoftwareMains voltage supply is faulty Screen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the Hard Disk Contents Error Messages on the ScreenTime and/or Date is not Correct TipsPage System Expansion Information about Boards System ExpansionRemoving the Main Unit Cover How to remove the main unit coverInstalling Memory Table of combinations of memory Locations for memory to be installedMemory to be installed Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Expansion cards to be installed Locations for expansion cards to be installedPress and raise the slot cover lock Remove the slot cover Installing expansion cardsInsert the expansion card into the port Install the installing fittingReplacing Lithium Battery