Fujitsu E623 user manual Installing memory

Page 42

Installing memory

IMPORTANT

Hold the edge of the memory as shown in the following figure. Be sure not to touch the areas (pins) with the indication of golden lines.

Do not touch these areas.

Memory

When installing or removing memory, take care so that the memory does not touch auxiliary fittings.

1Unplug your computer.

2Remove the upper cover.

3Remove the flat cable from the CD-ROM drive.

28

Image 42

Contents Deskpower E623 User’s Manual Important Safety Instructions Iii Before Reading this Manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Conventions Used in this Manual IntroductionNotational conventions Manufacturer’s notes SafetyImportant Notes Energy savingFCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorTransporting the PC Disposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Chapter External devices Steps for Initial SetupUnpacking and Checking the Delivery Drives and boardsSetting Up the PC Installing the FeetWhen two feet double are used Vertical positioningWhen one foot single is used Horizontal positioning Point Initial Switch-on Software will be Installed Switching on monitor and PCOperation Switching On the PC Switching Off the PCVent Power indicatorFront Panels of the Main Unit of the Personal Computer Smart card bayCD access indicator Disc access indicatorFloppy disk access indicator Microphone jackKey hole for a padlock Back Panel of the Main Unit of the Personal ComputerAGP card slot Antitheft lock Expansion card slotInlet Main switchOutlet LAN portCheck that the upper cover has been firmly installed Anti-theft Protection and Lead-sealingPage Troubleshooting Tips Installing New Software Mains voltage supply is faultyInternal power supply overloaded Screen stays blank Wrong monitor has been set under Window XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been insertedTime and/or Date is not Correct Error Messages on the ScreenRestoring the Hard Disk Contents TipsPage System Expansion System Expansion Information about BoardsHow to remove the main unit cover Removing the Main Unit CoverInstalling Memory Locations for memory to be installed Memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Locations for expansion cards to be installed Expansion cards to be installedInstalling expansion cards Press and raise the slot cover lock Remove the slot coverInstall the installing fitting Insert the expansion card into the portReplacing Lithium Battery