Fujitsu E623 user manual Time and/or Date is not Correct, Error Messages on the Screen, Tips

Page 35

Time and/or Date is not Correct

You can set the time and date in the BIOS Setup or in the operating system.

Set the time and date.

If the time and date are repeatedly wrong when you switch on your PC, the on-board battery is flat. Change the lithium battery as described in the "Extensions to the mainboard" - "Replacing lithium battery" chapter.

Error Messages on the Screen

Error messages and their explanation are contained:

In the technical manual for the mainboard

In the "BIOS Setup" manual

In the documentation for the programmes used

Restoring the Hard Disk Contents

Should you need to restore your hard disk, the instructions are provided on the case of the "Recovery CD" (delivered with your system).

Tips

The PC cannot be switched off with the ON/OFF switch

Cause: The PC was not switched on with the ON/OFF switch.

Press the ON/OFF switch again. Cause: System crash

Press and hold the ON/OFF switch for at least four seconds until the PC switches off.

Out of system resources

If you have too many applications running at once, you may experience problems due to a lack of system resources. In this case you should:

close unnecessary applications

or

run the applications in a different order

21

Image 35
Contents Deskpower E623 User’s Manual Important Safety Instructions Iii For Safe Operation Before Reading this ManualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Notational conventions Conventions Used in this ManualIntroduction Energy saving SafetyImportant Notes Manufacturer’s notesFCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Reference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents Chapter Drives and boards Steps for Initial SetupUnpacking and Checking the Delivery External devicesInstalling the Feet Setting Up the PCVertical positioning When two feet double are usedWhen one foot single is used Horizontal positioning Point Switching on monitor and PC Initial Switch-on Software will be InstalledOperation Switching Off the PC Switching On the PCSmart card bay Power indicatorFront Panels of the Main Unit of the Personal Computer VentMicrophone jack Disc access indicatorFloppy disk access indicator CD access indicatorExpansion card slot Back Panel of the Main Unit of the Personal ComputerAGP card slot Antitheft lock Key hole for a padlockLAN port Main switchOutlet InletAnti-theft Protection and Lead-sealing Check that the upper cover has been firmly installedPage Troubleshooting Tips Internal power supply overloaded Installing New SoftwareMains voltage supply is faulty Screen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XPTips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System ExpansionRemoving the Main Unit Cover How to remove the main unit coverInstalling Memory Table of combinations of memory Locations for memory to be installedMemory to be installed Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Expansion cards to be installed Locations for expansion cards to be installedPress and raise the slot cover lock Remove the slot cover Installing expansion cardsInsert the expansion card into the port Install the installing fittingReplacing Lithium Battery