Fujitsu E623 user manual

Page 43

4Raise the drive unit forward while pressing the lock button of the clamp. Pull and raise the drive unit until it is in the vertical position.

5 Open the hooks on the both sides of the slot outward.

6 Insert the slot into the memory.

Align the notch of the memory to the notch of the slot, and vertically insert the memory into the slot.

When the memory is correctly inserted, the hooks on the both sides of the slot are raised. Make sure that the hooks firmly hold the memory.

29

Image 43

Contents Deskpower E623 User’s Manual Important Safety Instructions Iii For Safe Operation Before Reading this ManualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Introduction Conventions Used in this ManualNotational conventions Energy saving SafetyImportant Notes Manufacturer’s notesFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCTransporting the PC Reference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents Chapter Drives and boards Steps for Initial SetupUnpacking and Checking the Delivery External devicesInstalling the Feet Setting Up the PCVertical positioning When two feet double are usedWhen one foot single is used Horizontal positioning Point Switching on monitor and PC Initial Switch-on Software will be InstalledOperation Switching Off the PC Switching On the PCSmart card bay Power indicatorFront Panels of the Main Unit of the Personal Computer VentMicrophone jack Disc access indicatorFloppy disk access indicator CD access indicatorExpansion card slot Back Panel of the Main Unit of the Personal ComputerAGP card slot Antitheft lock Key hole for a padlockLAN port Main switchOutlet InletAnti-theft Protection and Lead-sealing Check that the upper cover has been firmly installedPage Troubleshooting Tips Mains voltage supply is faulty Installing New SoftwareInternal power supply overloaded Screen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XPTips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System ExpansionRemoving the Main Unit Cover How to remove the main unit coverInstalling Memory Memory to be installed Locations for memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Expansion cards to be installed Locations for expansion cards to be installedPress and raise the slot cover lock Remove the slot cover Installing expansion cardsInsert the expansion card into the port Install the installing fittingReplacing Lithium Battery