Fujitsu E623 user manual Point

Page 21

POINT

For vertical installation, the main unit of the personal computer can be installed by fitting the five rubbers attached to the four corners and center of the main unit of the personal computers.

When installing rubbers, secure them in the positions where the foot does not touch when it is vertically installed. Wipe dust off the location where rubbers for the main unit of the personal computer are installed.

When moving the main unit of the personal computer after the rubbers have been installed, do not drug the rubbers.

7

Image 21

Contents Deskpower E623 User’s Manual Important Safety Instructions Iii For Safe Operation Before Reading this ManualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Conventions Used in this Manual IntroductionNotational conventions Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorTransporting the PC Reference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents Chapter Unpacking and Checking the Delivery Steps for Initial SetupExternal devices Drives and boardsInstalling the Feet Setting Up the PCVertical positioning When two feet double are usedWhen one foot single is used Horizontal positioning Point Switching on monitor and PC Initial Switch-on Software will be InstalledOperation Switching Off the PC Switching On the PCFront Panels of the Main Unit of the Personal Computer Power indicatorVent Smart card bayFloppy disk access indicator Disc access indicatorCD access indicator Microphone jackAGP card slot Antitheft lock Back Panel of the Main Unit of the Personal ComputerKey hole for a padlock Expansion card slotOutlet Main switchInlet LAN portAnti-theft Protection and Lead-sealing Check that the upper cover has been firmly installedPage Troubleshooting Tips Installing New Software Mains voltage supply is faultyInternal power supply overloaded Screen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the Hard Disk Contents Error Messages on the ScreenTime and/or Date is not Correct TipsPage System Expansion Information about Boards System ExpansionRemoving the Main Unit Cover How to remove the main unit coverInstalling Memory Locations for memory to be installed Memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Expansion cards to be installed Locations for expansion cards to be installedPress and raise the slot cover lock Remove the slot cover Installing expansion cardsInsert the expansion card into the port Install the installing fittingReplacing Lithium Battery