Fujitsu E623 user manual Iii

Page 3

13.Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power cord or plug is damaged or frayed.

b.If liquid has been spilled into the product.

c.If the product has been exposed to rain or water.

d.If the product does not operate normally when the operating instructions are followed. Adjust only those controls that are covered by the operating instructions since improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal condition.

e.If the product has been dropped or the cabinet has been damaged.

f.If the product exhibits a distinct change in performance, indicating a need for service.

14.CAUTION. When replacing the battery, be sure to install it with the polarities in the correct position. There is a danger of explosion if the battery is replaced with an incorrect type or is mistreated. Do not recharge, disassemble or dispose of in fire. Replace only with the same or equivalent type recommeded by the manufacturer. Dispose of the used battery according to the manufacturer’s instructions.

15.Use only the proper type of power supply cord set (provided in your accessories box) for this unit. It should be a detachable type: UL listed/CSA certified, BS1363, ASTA, SS145 certified, rated 10A 250V minimum, VDE approved or its equivalent. Maximum length is 15 feet (4.6 meters).

16.NOTE:

Please take extra precaution when connecting the LAN cable; do not connect the LAN cable to the peripheral device’s connector, that might have excessive voltage.

iii

Image 3
Contents Deskpower E623 User’s Manual Important Safety Instructions Iii For Safe Operation Before Reading this ManualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Conventions Used in this Manual IntroductionNotational conventions Energy saving SafetyImportant Notes Manufacturer’s notesFCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorTransporting the PC Reference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents Chapter Drives and boards Steps for Initial SetupUnpacking and Checking the Delivery External devicesInstalling the Feet Setting Up the PCVertical positioning When two feet double are usedWhen one foot single is used Horizontal positioning Point Switching on monitor and PC Initial Switch-on Software will be InstalledOperation Switching Off the PC Switching On the PCSmart card bay Power indicatorFront Panels of the Main Unit of the Personal Computer VentMicrophone jack Disc access indicatorFloppy disk access indicator CD access indicatorExpansion card slot Back Panel of the Main Unit of the Personal ComputerAGP card slot Antitheft lock Key hole for a padlockLAN port Main switchOutlet InletAnti-theft Protection and Lead-sealing Check that the upper cover has been firmly installedPage Troubleshooting Tips Installing New Software Mains voltage supply is faultyInternal power supply overloaded Screen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XPTips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System ExpansionRemoving the Main Unit Cover How to remove the main unit coverInstalling Memory Locations for memory to be installed Memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Expansion cards to be installed Locations for expansion cards to be installedPress and raise the slot cover lock Remove the slot cover Installing expansion cardsInsert the expansion card into the port Install the installing fittingReplacing Lithium Battery