Fujitsu E623 Unpacking and Checking the Delivery, Steps for Initial Setup, External devices

Page 16

Preparing for Use

CAUTION

Please take note of the safety information in the "Important notes" chapter.

■Unpacking and Checking the Delivery

It is recommended not to throw away the original packaging material! It may be required for reshipment at some later date.

●Unpack all the individual parts.

●Check the delivery for damage incurred during transportation.

●Check whether the delivery agrees with the details in the delivery note.

Should you discover that the delivery does not correspond to the delivery note, notify your local sales outlet immediately.

■Steps for Initial Setup

First-time setup includes the connection of the monitor, mouse and keyboard to the system unit and the setup of the supplied software.

External devices

If you have received other devices in addition to your PC (e.g. a printer or a modem), do not connect these until after the initial installation.

Drives and boards

If you have received drives or boards with your PC, please do not install them until after first-time setup. How to install drives and boards is described in the chapter "System expansions".

Perform the following steps in the prescribed order:

1.Decide where you are going to use the PC, and then set it up.

2.Connect the monitor, mouse and keyboard to the PC.

3.Check the rated voltage of the PC and connect it to the mains voltage.

4.Switch the PC on and follow the instructions on the screen.

2

Image 16

Contents Deskpower E623 User’s Manual Important Safety Instructions Iii Before Reading this Manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Introduction Conventions Used in this ManualNotational conventions Safety Important NotesManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCTransporting the PC Disposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Chapter Steps for Initial Setup Unpacking and Checking the DeliveryExternal devices Drives and boardsSetting Up the PC Installing the FeetWhen two feet double are used Vertical positioningWhen one foot single is used Horizontal positioning Point Initial Switch-on Software will be Installed Switching on monitor and PCOperation Switching On the PC Switching Off the PCPower indicator Front Panels of the Main Unit of the Personal ComputerVent Smart card bayDisc access indicator Floppy disk access indicatorCD access indicator Microphone jackBack Panel of the Main Unit of the Personal Computer AGP card slot Antitheft lockKey hole for a padlock Expansion card slotMain switch OutletInlet LAN portCheck that the upper cover has been firmly installed Anti-theft Protection and Lead-sealingPage Troubleshooting Tips Mains voltage supply is faulty Installing New SoftwareInternal power supply overloaded Screen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Window XP Wrong RAM modules have been insertedError Messages on the Screen Restoring the Hard Disk ContentsTime and/or Date is not Correct TipsPage System Expansion System Expansion Information about BoardsHow to remove the main unit cover Removing the Main Unit CoverInstalling Memory Memory to be installed Locations for memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Locations for expansion cards to be installed Expansion cards to be installedInstalling expansion cards Press and raise the slot cover lock Remove the slot coverInstall the installing fitting Insert the expansion card into the portReplacing Lithium Battery