Fujitsu E623 user manual Insert the expansion card into the port, Install the installing fitting

Page 49

POINT

Store the removed slot cover in a safe place.

When using an expansion card after removed, install so that dust does not enter the internal personal computer.

6Insert the expansion card into the port.

Firmly insert the expansion card into the port and secure it by returning the lock raised in Step 4.

7 Install the installing fitting.

Vertically install so that the tab is firmly positioned on the back side.

8Install the upper cover.

9Insert the power plug into a wall outlet, and then turn on the computer.

The device driver and resource are automatically set so that the expansion card can be used.

POINT

Store the removed slot cover in a safe place. After removing an expansion card, reinstall the slot cover so that dust does not enter the internals of the computer.

35

Image 49

Contents Deskpower E623 User’s Manual Important Safety Instructions Iii For Safe Operation Before Reading this ManualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Introduction Conventions Used in this ManualNotational conventions Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCTransporting the PC Reference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents Chapter Unpacking and Checking the Delivery Steps for Initial SetupExternal devices Drives and boardsInstalling the Feet Setting Up the PCVertical positioning When two feet double are usedWhen one foot single is used Horizontal positioning Point Switching on monitor and PC Initial Switch-on Software will be InstalledOperation Switching Off the PC Switching On the PCFront Panels of the Main Unit of the Personal Computer Power indicatorVent Smart card bayFloppy disk access indicator Disc access indicatorCD access indicator Microphone jackAGP card slot Antitheft lock Back Panel of the Main Unit of the Personal ComputerKey hole for a padlock Expansion card slotOutlet Main switchInlet LAN portAnti-theft Protection and Lead-sealing Check that the upper cover has been firmly installedPage Troubleshooting Tips Mains voltage supply is faulty Installing New SoftwareInternal power supply overloaded Screen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Window XP Wrong RAM modules have been insertedRestoring the Hard Disk Contents Error Messages on the ScreenTime and/or Date is not Correct TipsPage System Expansion Information about Boards System ExpansionRemoving the Main Unit Cover How to remove the main unit coverInstalling Memory Memory to be installed Locations for memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Expansion cards to be installed Locations for expansion cards to be installedPress and raise the slot cover lock Remove the slot cover Installing expansion cardsInsert the expansion card into the port Install the installing fittingReplacing Lithium Battery