Fujitsu D2630 technical manual Features, Overview, System board

Page 15

3 Features

3.1Overview

System board

Up to four Intel® XEON MP dual-core processors

Intel® E8501 chipset:

Intel® E8501 chipset Northbridge (TNB): has two shared 64-bit FSB interfaces configured for symmetric multiprocessing.

External Memory Board (XMB): provides support for DDR-2 memory.

PXH: provides support for PCI-X .

Intel® IOP333 I/O processor with Intel XScale® Microarchitecture: provides support for PCI-X and contains Intel XScale® technology to support RoMB (RAID on Motherboard).

Intel® 82801EB I/O controller Hub 5 (Southbridge) provides support for system BIOS, USB 2.0 and SATA.

Advanced I/O architecture:

One hot-plug x8 PCI-Express slot

Three hot-plug x4 PCI-Express slots

One hot-plug 133 MHz, 64-bit PCI-X slot

Two 100 MHz, 64-bit PCI-X slots (not hot-plug)

LSI Logic® 53C1030 LVD SCSI controller:

Dual independent U320 SCSI interfaces

64-bit PCI-X 100 Mhz interface

Integrated ATI Technologies Inc® Radeon 7000M with 16 MB embedded

SDRAM

D2630 (RX600 S3) SAS

11

Image 15
Contents System Board D2630 for RX600 S3 SAS Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections…Contents Page Notational conventions IntroductionPage Important notes Batteries ESD label CE Certificate CE CertificateEnvironment Protection Important notesEnvironmentally-friendly product design and development Environment Protection Symbols for electrical electronic devicesLocal contacts Returning batteriesPage Features OverviewSystem board Main memory External connectorsBios features OverviewFeatures Environmental protectionForm factor Memory board population Main memoryAssignment of the PCI interrupts PCI busPCI bus PCI slotsTemperature monitoring Screen resolutionTemperature / system monitoring Screen resolutionVoltage monitoring Fan monitoringFan control Sensor monitoringConnectors and jumpers Connectors and jumpersJ4A3 28 Bios Recovery Settings with jumpersJ4A1 26 Password Clear J4A2 27 Bios Write ProtectJ8C2 1 BMC Reset LAN connectorsJ4A4 29 Nvram Clear RoMB RoMBReplacing the RAID Controller Replacing the RAID ControllerReview the Jumpers and Connectors Unpack the controllerPrepare the Computer Jum Type Description Pers Remove the RAID SAS controller from the Mainboard LEDInstalling the new RAID SAS controller Power-Up the Computer Run the WebBIOS Configuration UtilityInstall the Operating System Driver Page Replacing the lithium battery holder is similar Replacing the lithium batteryPage Abbreviations Abbreviations Evrd LED RoHS RAIDWOL WfMComments Suggestions Corrections