Fujitsu D2630 technical manual J4A4 29 Nvram Clear, J8C2 1 BMC Reset, LAN connectors

Page 24

Connectors and jumpers

Features

J4A4 (29) - NVRAM Clear

1-2 NVRAM settings are not cleared

2-3 NVRAM settings cleared

J8C2 (1) - BMC Reset

1-2 BMC enabled

2-3 BMC disabled

3.6.1External connectors

1

2

3

4

5

6

Figure 8: External connectors I/O shield
1	= Video connector	4	= LAN 1
2	= Serial connector	5 = LAN 2
3	= Dual USB connector	6	= GCM connector (not used)

LAN connectors

On this system board you will find one GbE Broadcom LAN controller 5704C. This LAN controller supports the transfer rates of 10 Mbit/s, 100 Mbit/s and

1 Gbit/s. The LAN controller supports WOL function through Magic Packet™.

It is also possible to boot a device without its own boot hard disk via LAN. Here Intel PXE is supported.

20	D2630 (RX600 S3) SAS

Image 24

Contents System Board D2630 for RX600 S3 SAS Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOContents Page Introduction Notational conventionsPage Important notes Batteries ESD label CE Certificate CE CertificateEnvironment Protection Important notesEnvironmentally-friendly product design and development Symbols for electrical electronic devices Environment ProtectionReturning batteries Local contactsPage Features OverviewSystem board External connectors Bios featuresOverview Main memoryFeatures Environmental protectionForm factor Main memory Memory board populationPCI bus PCI busPCI slots Assignment of the PCI interruptsScreen resolution Temperature / system monitoringScreen resolution Temperature monitoringFan monitoring Fan controlSensor monitoring Voltage monitoringConnectors and jumpers Connectors and jumpersSettings with jumpers J4A1 26 Password ClearJ4A2 27 Bios Write Protect J4A3 28 Bios RecoveryJ8C2 1 BMC Reset LAN connectorsJ4A4 29 Nvram Clear RoMB RoMBReplacing the RAID Controller Replacing the RAID ControllerReview the Jumpers and Connectors Unpack the controllerPrepare the Computer Jum Type Description Pers LED Remove the RAID SAS controller from the MainboardInstalling the new RAID SAS controller Power-Up the Computer Run the WebBIOS Configuration UtilityInstall the Operating System Driver Page Replacing the lithium battery Replacing the lithium battery holder is similarPage Abbreviations Abbreviations Evrd LED RAID RoHSWfM WOLComments Suggestions Corrections